Ventev TW-HD-RPSMACOLO User manual

www.ventevinfra.com [e-mail] 800-851-4965
Co-Locating Mount for RPSMA Access Points
and Co-Located Ventev & Aruba Antennas
Ventev’s TerraWave Co-Locating Mount is designed to simplify deployments and reduce cable loss by placing the
access point and antenna inches apart. The mount consists of a baseplate that attaches directly to the AP and allows
mounting on or above ceiling tiles, and an antenna mounting tray that articulates +/- 25 degrees for precise beam
positioning. The locking screws lock and hold the antenna mounting tray in position so the antenna’s position will
not drift and will not drift over time. The mount hosts all Aruba 100, 200, and 300 series indoor access points,
Aerohive’s 121, 230, 330, and 390 access points, and Samsung’s 303e and 403e access points. The mount also hosts
Ventev Antennas, and several Aruba antennas, including the ANT-48 and ANT-4x4-5314 antennas.
Every Ventev Terrawave product is covered by the company’s two-year TerraNet warranty program. For questions or to
purchase product, contact a Regional Sales Executive at 410-229-1201, 800-851-4965 or [email protected].
Specications
Model TW-HD-RPSMACOLO
Dimensions (inch) 9.63” x 10.07” x 5.48”
Weight (lbs.) 2.2 lbs.
Material Powder Coated Aluminum
Operating Temperature Range (F°) -4° F to +131° F
RPSMA Co-Locating Mount without AP and antenna
Mount With Aruba AP and TerraWave Antenna
CompaƟble TerraWave Antennas (Listed by SKU)
501621 527504
572251 500885
333918 393218
544625
CompaƟble Aruba Antennas (Listed by Model)
AP‐ANT‐25A AP‐ANT‐28
AP‐ANT‐35A AP‐ANT‐38
AP‐ANT‐48AP‐ANT‐4x4‐5314

www.ventevinfra.com [e-mail] 800-851-4965
Co-Locating Mount for RPSMA Access Points
and Co-Located Ventev & Aruba Antennas
Overhead Attachment Point
Access Point Mounting Bar
Antenna Mounting Tray
Locking Screws
Mounting Instructions
1. Connect the Access Point’s plastic clip to the Access Point (if required). Consult the Access Point
documentation for plastic clip directions.
2. Place the Access Point clip against the Co-Locating Mount’s Mounting Bar and rotate so that plastic
clips t over the Mounting Bar and holds the Access Point in place.
3. Remove nuts and washers from Antenna mounting bolts. Push the Antennas mounting bolts
through the holes in the Antenna Mounting Tray.
4. Re-attach antenna washers and nuts to hold antenna securely against Mounting Tray. Run antenna
cables through cable management clips and attach cable connectors to Access Point.
5. Bolt the Co-Locating Mount onto the preferred overhead location. Note: Overhead mounting
hardware must be purchased separately by user.
6. Position antenna (if required) - Loosen the Antenna Mounting Tray’s locking nuts. Rotate the
Antenna Mounting Tray to achieve the desired antenna position. Tighten the locking nuts.