Installation Guide
1. Prepare a round hole through the wall. The
hole size is shown below.
VENTILATOR MOUNTING
2. Assemble inner duct and outer duct
together, then cut to cater to the thickness of
the wall. Paste waterproof sealing glue on the
inner side of the rubber ring, shown below.
3. Pull back the duct through the wall hole to
make the inner side rubber ring fix to the
outside wall. Fill the gap between the wall and
duct with foam glue. The inner duct should be
perpendicular with indoor wall surface.
4. Paste the location sticker onto the wall
surface, paying attention to the direction
ensuring the circle marked on the sticker lines
up with the duct. Mark the drilling hole positions
and remove sticker. Drill 4 x 6 mm holes and fill
holes with rubber wall plugs (supplied).
Caution: The ventilator must not be installed in
a location where the air duct will be obstructed
by curtains, blinds or other item that can
interfere with the air flow.
Installation Guide
2Ventilators Australia 3Ventilators Australia
