Visual Comfort & Co. Forma KW 1250 User manual

1. Carefully remove all parts from the box.
2. Unscrew the knurled screws (C) from the fixture (A).
3. Insert bulb (not included) into the socket. .
4. Place shade (D) on the fixture (A) and secure with knurled screws (C)
5. Remove protective plug cover (B) from the plug.
6. Plug into a proper electrical outlet and test the fixture.
7. Installation is complete.
***Clean with a dry, soft cloth only. Use no harsh abrasives or chemical agents.
Forma Floor Lamp
Item # KW 1250
INSPECT ITEM CAREFULLY BEFORE ATTEMPTING TO INSTALL. IF THERE IS ANY
DAMAGE OR OBVIOUS DEFECT. DO NOT INSTALL.
ITEM MAY NOT BE RETURNED ONCE IT HAS BEEN INSTALLED.
DRY
NOTE: CAREFULLY UNPACK EACH PIECE IN TOP LAYER OF PACKING PRIOR TO
REMOVING.
RETAIN ALL PACKING MATERIAL UNTILL INSPECTION AND INSTALLATION ARE
FINAL.

Forma Floor Lamp
Item # KW1250
22008 N. Berwick Drive | Houston. TX 77095 | 713.686.5999 tel | 713.686.7444 fax
1. To properly remove lamp from carton, first remove the glass shade (A)
from foam casing.
2. Carefully stand carton upright with lamp base near floor as shown in figure.
3. Grasp base (B) and gently slide lamp out of foam casing.
B
THE FOLLOWING INSTRUCTIONS SHOULD BE READ PRIOR TO UNPACKING
YOUR PRODUCT AS THEY ARE INTENDED TO REDUCE OR ELIMINATE ANY
POSSIBLE DAMAGE.
UNPACKING NOTICE
A