Visual Comfort & Co. Cleo KW 1088 User manual

1. Carefully remove all parts from fox.
2. Attach metal shade (B) to the socket cup (A) and secure with thread ring (C).
3. Insert bulb (not included) into the socket.
4. Remove protective plug cover (D) from the plug.
5. Plug into a proper electrical outlet and test the fixture.
6. Installation is complete.
***Clean with a dry, soft cloth only. Use no harsh abrasives or chemical agents.
Cleo Floor Lamp
Item # KW 1088
WE RECOMMEND INSTALLATION OF THIS LIGHTING FIXTURE BE DONE BY A
LICENSED ELECTRICIAN.
WARNING***SWITCH OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN
FUSE BOX/CIRCUIT BREAKER BEFORE INSTALLATION.
INSPECT ITEM CAREFULLY BEFORE ATTEMPTING TO INSTALL. IF THERE IS ANY
DAMAGE OR OBVIOUS DEFECT. DO NOT INSTALL.
ITEM MAY NOT BE RETURNED ONCE IT HAS BEEN INSTALLED.
DRY

Cleo Floor Lamp
Item # KW1088
1. To properly remove lamp from carton, first remove the shade (A) from
foam casing.
2. Carefully stand carton upright with lamp base near floor as shown in figure.
3. Grasp marble ball/base (B) and gently slide lamp out of foam casing.
THE FOLLOWING INSTRUCTIONS SHOULD BE READ PRIOR TO UNPACKING
YOUR PRODUCT AS THEY AR E INTE NDED TO REDUCE OR ELIMINATE ANY
POSSIBLE DAMAGE.
UNPACKING NOTICE
A
B