Vivo Link VLSPH620WT User manual

Unpacking the Speakers
Carefully unpack the speakers and retain the carton and packing materials for future
use.
Wiring the speakers
Note: Please turn off and unplug your system prior to making any connections.
To wire your system, please use good quality, speaker grade audio cable with
polarity coding (usually identified with a marking on the cable) as per the gauge
recommendations indicated below. The side of the cable that has the coding (a
ridge, or "+" marking) usually denotes the positive polarity.
Up to 7.5m 15m >15m
Gauge 18 16 14
VLSPH620WT

Listening Test
Once you have connected your speakers, turn on your system and begin playback
of material you are familiar with. Begin at low volume and increase to a comfortable
listening level. The system should sound balanced with stereo sound. if the sound is
distorted and confused, check to make sure that the speakers have been correctly
wired to your amplifier/receiver.
Maintenance
Simply use a damp cloth to clean, avoid use of chemical products and polishes .
Specifications:
100 W Max Power
Impedance: 8 ohm
Transformer: 32w-16w-8w-4w(100V)
Frequency: 50-20k Hz
6.5” PP Cone Woofer
1 ”
Mylar Tweeter
This box includes:
ONE PAIR VLSPH620WT SPEAKERS
MOUNTING BRACKETS
Connect the positive lead of the speaker wire (indicated with a "+" ) to the Red (or
positive) speaker terminal. Connect the other speaker wire lead to the Black (or
negative) speaker terminal.
Connect the opposite end of the speaker wire to your amplifier making sure that the
polarity is preserved ("+" to "+" or Red to Red, and "-" to "-" or Black to Black ). see
diagram below
Amplifier
Left Speaker
Left Right
Right Speaker
Speaker Connections
MADE IN CHINA