
2 3
ASSEMBLY STEPS
STEP 3
Slide the VESA plate with monitor onto the head of the mounting
arm, and secure with the thumbscrew (C).
WARNING!
If you do not understand these directions, or if you have any doubts about the safety of the installation, please call a
qualified technician. Check carefully to make sure there are no missing or defective parts. Improper installation may
cause damage or serious injury. Do not use this product for any purpose that is not explicitly specified in this manual. Do
not exceed weight capacity. We cannot be liable for damage or injury caused by improper mounting, incorrect assembly
or inappropriate use.
Adjust the tilt and swivel joints with the Allen
wrench (F). Use the cable clip to organize cables.
STEP 1
STEP 2
OPTION A: Flat Back Monitor
Attach VESA plate (B) to monitor using 12mm
screws (M-A, M-C) with washers (M-E).
OPTION B: Curved Back Monitor
Attach VESA plate (B) to monitor using
16mm screws (M-B, M-D) with washers
(M-E) and spacers (M-F).
STEP 4
Slide mounting arm (A) onto
pole and tighten bolts using
the 6mm Allen wrench (F). For
pole sizes larger than 45mm,
swap pre-installed bolts with
M8x70 bolts (D). Attach cable
clip (E) to arm.
PACKAGE CONTENTS
D(x2)
M8x70
C(x1)
Thumbscrew
A(x1)
Mounting Arm
E(x1)
Cable Clip
M-E (x4)
D5 Washer
M-D (x4)
M5x16
M-C (x4)
M5x12
F(x1)
6mm Allen
Wrench
B(x1)
VESA Plate
M-A (x4)
M4x12
M-B (x4)
M4x16
M-F (x4)
Spacer
NOTE: NOT ALL HARDWARE INCLUDED WILL BE USED
TOOLS NEEDED
Phillips
Screwdriver
DO NOT EXCEED WEIGHT CAPACITY.
Failure to do so may result in serious injury.
17.6lbs
(8kg)
WARNING: CHOKING HAZARD
SMALL PARTS - NOT FOR CHILDREN UNDER 3 YEARS. ADULT SUPERVISION IS REQUIRED.
Adjust as Desired