Vivo STAND V003 User manual

   
Instruction Manual
Email: [e-mail]
Live chat: www.vivo-us.com
Call: 1-800-371- 6 4
-  
 
phillips screwdriver
 
1
Scan the QR code with your mobile device or follow the link
to helpful videos and specifications related to this product.
- -   !" 
 (x1)
48mm Pole
# (x1)
Clamp
 (x1)
Arm Assembly
 (x12)
M4x12
 (x12)
M4x30
$ (x24)
M4 Washer
 (x12)
M4 Spacer
 (x2)
M8x10
 (x2)
M10x15
% (x1)
Alle Key
 (x2)
Spare Plast c Cover
 (x1)
Wrech

"#& 
2
 ' (  )* "   
 
Install clamp (b) to pole (a) using M10x1 bolts (i) and tighten with
6mm Allen key (j). The height of the clamp (b) can be secured at three
different positions depending on the thickness of your desktop.
Carefully slide arm assembly (c) onto pole (a), making sure the cable
clips are facing down. Secure with M8x10 bolts (h) using a Phillips
screwdriver.
 + ( "   # 

 ,   -  %  

Manage cables for side monitors using the cable clips. Cables can also
be hidden inside the pole.
To adjust swivel joints, remove the plastic cover, then use the 6mm
Allen key (j) to turn the bolt.
      . 
/ 0
  0
Use M4x12 thumb screws
(d) with washers (f) to
mount flat back monitors.
Thumb screws only need
to be finger-tight.
Use M4x30 screws (e) with
washers (f) and spacers (g)
for curved or recessed back
monitors. Do not over-
tighten.
3

If you do not understand these directions, or if you have any
doubts about the safety of the installation, please call a
qualified technician. Check carefully to make sure there are no
missing or defective parts. Improper installation may cause
damage or serious injury. Do not use this product for any
purpose that is not explicitly specified in this manual. We
cannot be liable for damage or injury caused by incorrect
assembly or inappropriate use.
Email: [e-mail]
Live chat: www.vivo-us.com
Call: 1-800-371- 6 4
For more VIVO products, check out our
website at
www.vivo-us.com.
If any parts are received damaged or defective, please contact
us. We are happy to replace parts to ensure you have a fully
functioning product.
$& -
  
Last updated: 0 /04/18
 1 /2     %  3  $
 
To adjust the tilt joints, remove the plastic cover from the side of the
joint and turn the nut using the wrench (l).
To adjust the independent center monitor height, turn the bolt on
top using the mm Allen wrench (j). Counter-clockwise will lower the
monitor, and clockwise will raise the monitor.
4