Vladimir's Models SNIPE 2 EL User manual

SNIPE 2 EL
Recommendations for assembly
1
1. The list of parts and materials to build:
Accessory kit: Parts set:
1. Elevator spring;
2. Rudder spring;
3. Snipe 2 electric elevator and rudder control horns;
4. Pipes for the fixing control cables (1pc is spare);
5. Screws for wing and rudder M3x10 ( 3pcs are
spare)
6. Snipe elevator and rudder control steel cable;
7. Snipe 2 aileron ball head aluminum screws (2 pcs);
8. Carboline SC 78 4/30 carbon for fixing aileron
horn pins;
9. Snipe 2 aluminum aileron control horns set (left
and right);
10. Aileron horn pins (2 pcs).
11. Accessoires of Snipe 2 El kit;
12. Tail boom;
13. Fuselage;
14. Canopy;
15. Rudder;
16. Horizontal stabilizer;
17. Wing.
The list of materials needed to build the model:
1) Superglue and liquid medium, the accelerator
2) Cutter
3) Masking tape
4) Pen and ruler
5) Pliers
6) Sandpaper number 240-320
All manuals and user guides at all-guides.com
all-guides.com

SNIPE 2 EL
Recommendations for assembly
2
2. Assembling the model
2.1 Aileron horns installation.
This is very important sequence to follow for successful control installation.
Place a small piece of tape on bottom of flap over
control horn and make small hole in flap with pin for
glue hole.
CAUTION!
Gluing zone of aluminium horn is covered with
primer for epoxy and CA!
All manuals and user guides at all-guides.com

SNIPE 2 EL
Recommendations for assembly
3
Glue pins in groves at bottom of wing.
Reinforce aileron’s pins by 2-3 layers of Carboline
SC 39 2/45 (8x14 mm).
All manuals and user guides at all-guides.com

SNIPE 2 EL
Recommendations for assembly
4
All manuals and user guides at all-guides.com

SNIPE 2 EL
Recommendations for assembly
5
Then slide control horn into slot in flap. Next, slide control horn on pin and push horn to inside edge of hole,
toward center of wing. Leave just enough clearance between horn and hole so the horn does not scrape edge of
hole.
Use some thin CA and drip glue into pin hole. When CA is dry, remove tape. Pull flap down and fill space
around control horn with CA.
All manuals and user guides at all-guides.com

SNIPE 2 EL
Recommendations for assembly
6
2.2 Snipe 2 EL Fuselage.
All manuals and user guides at all-guides.com
all-guides.com

SNIPE 2 EL
Recommendations for assembly
7
2.3 Snipe 2 Electric fuselage KST x08h mount plate
All manuals and user guides at all-guides.com

SNIPE 2 EL
Recommendations for assembly
8
All manuals and user guides at all-guides.com

SNIPE 2 EL
Recommendations for assembly
9
2.4 Snipe 2 EL Tail
All manuals and user guides at all-guides.com