Fisher-Price Shake'N Go Crash-Ups L3776 User manual

Each sold separately and subject to availability.
www.fisher-price.com
K5874
L3776 L3779
L3778 L3777
TM

• Locate the battery compartment door
on the bottom of each car.
• Loosen the screw in the battery
compartment door with a Phillips
screwdriver. Remove the battery
compartment door.
• Remove the exhausted batteries and
throw them away.
• Insert three, new "AA" (LR6)
alkaline batteries.
Hint: We recommend using alkaline
batteries for longer battery life.
• Replace the battery compartment
door and tighten the screw with a
Phillips screwdriver. Do not
over-tighten.
• When sounds or motions become
faint or stop, it’s time for an adult to
change the batteries!
For best performance, we recommend
replacing the batteries that came with
this toy with three, new alkaline “AA”
(LR6) batteries.
In exceptional circumstances, batteries
may leak fluids that can cause a
chemical burn injury or ruin your toy. To
avoid battery leakage:
• Do not mix old and new batteries or
batteries of different types: alkaline,
standard (carbon-zinc) or recharge-
able (nickel-cadmium).
• Insert batteries as indicated inside the
battery compartment.
• Remove batteries during long periods
of non-use. Always remove exhausted
batteries from the toy. Dispose of
batteries safely. Do not dispose of the
product in a fire. The batteries inside
may explode or leak.
• Never short-circuit the battery
terminals.
• Use only batteries of the same or
equivalent type, as recommended.
• Do not charge non-rechargeable
batteries.
• Remove rechargeable batteries from
the toy before charging.
• If removable, rechargeable batteries
are used, they are only to be charged
under adult supervision.
• Protect the environment by not
disposing of this product with
household waste (2002/96/
EC). Check your local authority
for recycling advice and
facilities (Europe only).
Battery Replacement Battery Safety
Information
1,5V x 3
"AA" (LR6)

Shake... Crash... Reset... Re-Smash!
Bottom View
• Slide the On/Off switch on the bottom
of the car to on.
• Lift the car and shake it to start the
"engine" and the sound effects.
Hint: For maximum distance, shake
the car 7 or 8 times. Shaking more
than this does not increase the
distance it will travel.
• Set the car down and let it go. The car
races up to 20 feet (6 m)!
• Crash your car and see the parts fly!
Note: Use only projectiles (spoiler)
supplied with this toy. Do not launch at
people or animals or at point blank range.
1
3
2
Note: Plastic tabs are attached to the
toy for in-store demonstration purposes.
While the tabs may have already been
removed, check the bottom of the toy to
be sure. If a plastic tab is still attached,
pull and remove the tab. Throw the
plastic tabs away.
CAUTION
Please keep small parts such
as plastic tabs out of children’s
reach. Throw the plastic tabs away.
• To reset the car, press down on the
hood area. Insert the spoiler into
the hole at the rear of the car until it
"clicks" in place.
• When you're finished, slide the On/Off
switch to off.
4
Race your cars on the
Shake ’n Go Crash-up Speedway!
Sold separately and subject to availability.

Fisher-Price, Inc., a subsidiary of Mattel, Inc., East Aurora, NY 14052 U.S.A.
©2007 Mattel, Inc. All Rights Reserved. ® and ™ designate U.S. trademarks of Mattel, Inc.
PRINTED IN CHINA L3776pr-0920
United States Only
This equipment has been tested and
found to comply with the limits for
a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits
are designed to provide reasonable
protection against harmful interference
in a residential installation. This
equipment generates, uses and can
radiate radio frequency energy and, if
not installed and used in accordance
with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that
interference will not occur in a particular
installation. If this equipment does
cause harmful interference to radio
or television reception, which can be
determined by turning the equipment off
and on, the user is encouraged to try to
correct the interference by one or more
of the following measures:
• Reorient or relocate the receiving
antenna.
• Increase the separation between the
equipment and receiver.
• Consult the dealer or an experienced
radio/TV technician for help.
Note: Changes or modifications not
expressly approved by the manu-
facturer responsible for compliance
could void the user’s authority to
operate the equipment.
FCC Statement
• Please keep this instruction sheet
for future reference, as it contains
important information.
• Requires three "AA" batteries
(included). Adult assembly is required
(for battery replacement).
• Tool required for battery replacement:
Phillips screwdriver (not included).
• This product is not recommended for
use on loose dirt or wet surfaces.
• Wipe this toy with a clean cloth
dampened with a mild soap and
water solution. Do not immerse
this toy.
• This toy has no consumer serviceable
parts. Do not take this toy apart.
CareConsumer Information