Voltex CFWL User manual

CEILING FAN INSTALLATION
INSTRUCTIONS
BUSINESS NAME:
CONTACT:
INSTALLATION DATE:
CFWL, CFBL, CFW, CFB

INSTALLATION NOTES

4
CEILING FAN INSTALLATION INSTRUCTIONS
IMPORTANT INSTALLATION, USER & WARRANTY INSTRUCTIONS
¬ Please read these instructions carefully before installing and using the appliance. Keep the
instructions handy for future reference.
¬ Before installing the ceiling fan, disconnect the power supply.
¬IMPORTANT: This appliance does not come with a cord or a plug. It must be installed in accordance
with national and local council building regulations, and the Australian and New Zealand wiring rules
AS/NZS 3000 latest edition thereof.
¬ALL ELECTRICAL WORK MUST BE CARRIED OUT BY A LICENSED ELECTRICAL CONTRACTOR OR
ELECTRICIAN.
¬AFTER INSTALLATION, DISCONNECTION OF THE APPLIANCE FROM THE SUPPLY SHALL BE POSSIBLE.
AN ALL-POLE DISCONNECTION MUST BE INCORPORATED INTO THE FIXED WIRING IN ACCORDANCE
WITH THE WIRING RULES.
¬THE MOUNTING OF THE SUSPENSION SYSTEM SHALL BE PEFORMED BY SUITABLY QUALIFIED
PERSONS ONLY.
¬ This ceiling fan has been designed to operate on a nominal supply voltage of 230-240Va.c. 50Hz
and in ambient temperatures between 5°C to 40°C.
¬ The weight of the ceiling fan is 7.7kg.
¬ The hanger bracket must be securely attached to a structural member such as a ceiling joist
for support with sufficient strength to withstand 4 times the weight of the ceiling fan (45 kg
recommended).
¬ The ceiling fan must be installed so that the blades are at least 2.1 m above the floor and 300 mm
from the tip of the blade to the nearest object or walls. Make sure the installation site you choose
allows the fan blades to rotate without any obstructions.
¬ The ceiling fan is suitable for pitched ceilings with a maximum angle of 20°
¬ This ceiling fan is designed for indoor and alfresco areas only. When installed in an alfresco area,
the ceiling fan must be positioned in a location protected from water, salt spray, mist, wind and/
or dust. Exposure to these elements will void the warranty. Mounting the fan in a situation where
it is subject to water or moisture is dangerous and may increase the risk of damage, injury or
electrical shock.
¬ Extended exposure to UV rays (such as exposure to direct sunlight) may cause discolouration of this
ceiling fan.
¬ The appliance must be properly connected to the protective earthing conductor in the installation
wiring of the installation.
¬ Ensure that the ceiling fan has been correctly installed and tested for safe operation before
reconnecting the power supply.

INSTALLATION INSTRUCTIONS
5
GENERAL SAFETY WARNINGS
SAFETY PRECAUTIONS FOR BATTERIES
1. This appliance is not intended for use by persons (including children) with reduced
physical, sensory, or mental capabilities, or lack of experience and knowledge,
unless they have been given supervision or instruction concerning use of the
appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance.
2. Use this appliance only as described in this manual. Any other use not
recommended by Voltex Electrical may cause fire, electric shock, or injury to
persons and void the warranty. If you have questions, please contact Voltex
Electrical first.
3. WARNING: If unusual wobbling or oscillating movement is observed, immediately
stop using the ceiling fan and contact Volex Electrical or suitably qualified persons.
4. This appliance is intended for household use and similar applications only. It is not
suitable for use in an environment heavily laden with dust.
5. Do not operate any appliance that malfunctions or is dropped or appears damaged
in any way.
6. Do not allow any foreign object to enter through the lens opening or the rear of the
appliance as this may damage the appliance and/or the user.
7. There are no user-serviceable parts inside the appliance. Contact your local
electrician if servicing is required.
8. The replacement of parts of the safety suspension system device shall be
performed by suitably qualified persons only.
9. Make sure that the power supply is properly disconnected before maintenance.
10. Make sure the fan is switched off from the supply mains before cleaning.
1. Always use 2 x AAA battery type for CFWL CFBL and 1 x A23 12V battery type for
CFW CFB with this ceiling fan remote controller.
2. Ensure the batteries are inserted with the correct polarity.
3. Remove batteries from the remote control when not in use for long periods of time.
4. Batteries must be removed from the remote controller before it is discarded.

6
PARTS LIST
NO. ITEM QUANTITY
1Hanger Bracket 1
2Down rod Assembly 1
3Canopy 1
4Clevis Pin 1
5Hairclip Pin 1
6Canopy Screws 2
7Magnetic Cover 1
8Coupling Cover 1
9Top Housing 1
10 Fan Motor Assembly 1
11 Blade Screws 6
12 Blades 3
13 LED Light Kit 1
14 Lampshade 1
15 Remote Control 1
16 Receiver 1
17 Remote Holder 1

INSTALLATION INSTRUCTIONS
7
15
16
17
1
3
2
5
6
4
7
10
11
13
12
14
8
9

8
INSTALLATION
This fan is designed for indoor spaces. Though not waterproof, it can be installed in alfresco settings and
coastal regions, as long as it is installed in an area safe from water, wind and dust, with at least one wall
on the side. If exposed to these elements, the warranty will be voided. Mounting the fan in a situation
where it is subject to water or moisture poses a safety risk.
Securely attach the hanger bracket to the ceiling using mounting screws.
Mounting
Screw (x2)
Hanger
Bracket
Ceiling joist
NOTE: The ceiling fan must be installed 300mm minimum from the tip
of the blade to nearest object or wall.
The screws provided are for use with wooden supports only, if the
support is not wooden, appropriate screws must be used.
Connect 240V mains power to the terminal Block located on the hanger
bracket.
1
2

INSTALLATION INSTRUCTIONS
9
Attach fan blades to motor using blade screws provided.
Carefully lift the fan and place the down rod with hanger ball assembly onto
the hanger bracket. Ensure that the groove in the ball is correctly aligned
with the tab on the hanger bracket.
Groove
Tab
Hanger
Bracket
Safety
Chain
Ceiling joist
3
4

10
Take the canopy and twist onto the pre-loosened ceiling mount screws
carefully.
Once the canopy is attached, slide the magnetic ring up to cover the screws.
Plug in all leads from the power input to the receiver.
5
6

INSTALLATION INSTRUCTIONS
11
REMOTE CONTROL SETTINGS
AND OPERATIONS
1. Fan Off
2. Speeds 1-6
3. Reverse – Summer/Winter
4. Dim up. (Press, or press and hold dim up button
for continuous dimming)
5. Dim down. (Press, or press and hold dim down
button for continuous dimming)
6. Light On/Off
7. Tri Colour Change
8. Timer function
1. Power On
2. Power Off
3. Speeds 1-5
4. Reverse – Summer/Winter
5. Timer Functions
CFWL, CFBL
6
7
8
1
2
3
4
5
CFW, CFB
1H
1 5
3
2 4
ON OFF
2H 4H
1
3
4
5
2

CLEANING SAFEGUARDS
∂WARNING Isolate the electrical supply before doing any cleaning of this product
∂Periodic cleaning of your ceiling fan is the only maintenance required.
∂It is recommended to clean every 6 months.
∂Use a soft brush or lint free cloth to avoid scratching the paint finish.
∂Do not soak or immerse your product in water or other liquids. It could damage
the product and create the possibility of an electrical shock.
∂Ensure that the product does not come in contact with any organic solvents or
cleaners.
∂To clean the fan blade, wipe with only a damp clean lint free cloth with NO
cleaning agents or solvents.
∂The motor has a permanently lubricated ball bearing so there is no need to oil.
∂The LED lamp in the fan is built-in and is non-replaceable.
© Voltex Electrical 2023. All Rights Reserved.
AU P: 1300 722 275
E: [email protected]
www.voltex.com
NZ P: 0800 55 66 33
E: [email protected]
www.voltex.com
The LED lamp shade is built in and non-replaceable, the homeowner should
never open the cover
Voltex warrants all its ceiling fans against defective workmanship and faulty materials for
7 years from the original date of purchase. Please retain proof of purchase and electrical
certificate of compliance.
Contact Voltex Electrical on 1300 722 275 (Australia)
or 0800 55 66 33 (New Zealand) for any warranty claims.