Vremi VRM050659N User manual

Inatable Air Mattress

Important Safety Instructions
Operation
Care & Cleaning
Warranty
Warning
Drop Us A Line
4
5
6
6
6
6
TABLE OF CONTENTS

4 5
1. Make sure the optional ination air valve is securely closed.
2. Plug the AC electrical line cord into an AC electrical outlet
protected by a ground-fault circuit interrupter. Check the
correct voltage before connecting.
3. Turn the Knob to the INFLATE position. The pump will start
inating automatically.
4. When the mattress is fully inated, turn the Knob to the
OFF position.
5. Disconnect the AC line cord from the wall socket.
6. Always keep the Knob on the OFF Position while the mattress
is in use.
Tips: Over pressure protection is on while inating. There is a
blow-off valve inside of pump which will be triggered once the
pressure is up to 3.5 Kpa (0.507 psi).
Manual Ination Option
If the electric pump is not available then a conventional foot or
manual air pump can be connected to the optional ination valve
for ination.
Note: Do not use air compressor or high pressure pumps. Do not
over inate - excessive ination of the air chambers can cause the
chamber to burst or damage to the welding seams.
1. Remove the valve totally from the valve insertion. Then pull the
stopper out of the valve extension. Inate the mattress by air
pumps. Blow in sufcient air until the chamber is fully inated.
2. Close the valve by rmly inserting the stopper and pressing the
valve into the chamber.
IMPORTANT SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS
For Household Use Only
Before using this appliance, please read the manual carefully and keep it for future reference. Incorrect operation due to ignoring
of instructions may cause harm or damage. Always observe the following important safety instructions.
1. WARNING: To prevent possible electric shock, do not attempt to plug in power cord with wet hands.
2. WARNING: To prevent possible electric shock, connect power cord into a grounded receptacle protected by a ground-fault circuit
interrupter (GFCI).
3. WARNING: To prevent possible electric shock, never use a damaged power cord. If the supply cord is damaged, it must be
replaced by the manufacturer or its service agent or a similarly qualied person in order to avoid a hazard.
4. WARNING: Do not use extension power cords with this product.
5. WARNING: This appliance is for indoor household use only. Keep it away from re.
6. WARNING: In order to reduce the risk of electric shock, do not expose it to rain. Store indoors.
7. RISK OF COMBUSTION: Do not place the air mattress against or near any open ames, heaters, furnaces or other hot objects.
8. IMPORTANT: Do not operate the electric pump for more than 4 minutes at one time, take 5 minutes break between uses, as
overheating may occur and the pump will automatically shut off. It will be ready to use after cooling down. This automatic shut off is
for your safety. Unplug the electrical power cord when it is not in use.
9. WARNING: Do not obstruct the air passage opening or insert any objects into the opening at any time.
10. WARNING: Do not stand, jump or use the air mattress as a trampoline. Always supervise children near the air mattress.
11. WARNING: This product is not a raft or oatation device. Do not use it near or in the water.
12. WARNING: Children must not be left unattended when using the air mattress.
13. WARNING: The storage bag is not a toy. To avoid danger of suffocation, keep the air mattress storage bag and any other bags
away from children. Fold up the bag and store away from children when not in use.
14. WARNING: Keep pets away from the air mattress. Pets may tear or puncture the air mattress.
15. IMPORTANT: Make sure the area is at, smooth and free of sharp objects that can puncture the air mattress. Do not set up the air
mattress near stairs, doors, drops, sharp edges or breakables.
16. IMPORTANT: To minimize any chance of rolling, tipping or swaying, avoid sleeping on the edge of the air mattress. Edges provide
less support than the middle of the air mattress.
17. IMPORTANT: This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory
or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of
the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user
maintenance shall not be made by children without supervision.
18. WARNING: Infants have suffocated on inatable mattresses. Never place infant aged birth to 15 months to sleep on this inatable
air mattress/air bed. Infants can suffocate on an under inated or deated mattress, on bedding, by co-sleeping with another
person, and by entrapment between the mattress and bed frame or between the mattress and a vertical surface.
19. WARNING: Children can be entrapped between the inatable mattress and an adjacent vertical surface. Provide at least a
shoulder width space between the inatable mattress/air bed and adjacent vertical surfaces such as walls, dressers, or other
objects.
20. WARNING: Always keep the inatable mattress fully inated when in use.
21. WARNING: To reduce the risk of electric shock, always unplug the power cord from the electrical outlet before cleaning.
THIS MATTRESS IS INTENDED TO BE USED WITHOUT A FOUNDATION. This mattress meets the requirements of 16 CFR part 1633
(federal ammability (open ame) standard for mattresses) when used without a foundation. 8017253
Operation
INFLATION INSTRUCTIONS
DEFLATION INSTRUCTIONS
1. Make sure the optional ination air valve is securely closed.
2. Plug the AC electrical line cord into an AC electrical outlet
protected by a ground-fault circuit interrupter.
3. Turn the Knob to DEFLATE position. The pump will start
deating automatically.
4. When deation is completed, turn the Knob to OFF position.
5. Disconnect the AC line cord from the wall socket.
6. Always keep the Knob to OFF position before storage and
maintenance.
Manual Deation Option
Remove the valve from the valve insertion. Then pull the stopper
out of the valve extension. It should deate the air. To get all of
the air out, start to fold or roll the mattress starting from the end
opposite of the air hole and moving towards it.
Example of air pump
Valve Insertion
Valve
Stopper

67
Care & Cleaning
CLEANING AND MAINTENANCE
1. Wipe the appliance clean with a mild soapy solution, then leave
it in a shady and cool place to dry.
Caution: Do not use any alkali, chemical or acid detergent to clean
the appliance. Do not leave or store the appliance in places where
it is likely to be exposed to extreme temperature or direct sunlight,
as it will shorten the life of the appliance.
2. Fold the air mattress loosely and avoid sharp bends, corners and
creases to avoid damage to the air mattress.
3. No specic maintenance is required for the built-in electric
pump.
4. Place the air mattress inside the storage bag and store in a dry
and indoor place.
REPAIR INSTRUCTIONS
Small pinhole and puncture leaks can be repaired with the
included repair patch.
1. Locate the leak place.
2. Deate the air mattress.
3. Clean the area surrounding the leakage.
4. Cut the repair patch into required shape and size, which should
be a little larger than the leaking area. Stick the patch on the
leaking area and press rmly.
5. Wait for more than 30 minutes before you start inating.
Note: If the damage area is bigger than 1” (2.5cm), we recommend
using silicone or rubber based glue for repair. Read warning
statement on the glue prior to use.
Vremi offers a 12-month warranty on all of our products purchased new and unused from Vremi LLC or an authorized reseller,
with an original proof of purchase and where a defect has arisen, wholly or substantially, as a result of faulty manufacturing, parts or
workmanship during the Warranty Period. The warranty does not apply where damage is caused by other factors, including without
limitation: (a) normal wear and tear; (b) abuse, mishandling, accident or failure to follow operating instructions; (c) exposure to liquid
or inltration of foreign particles; (d) servicing or modication of the product other than by Vremi. These are our general terms for the
warranty service, but we always urge our customers to reach out to us with any issue, regardless of warranty terms. If you experience an
issue with a Vremi product, please contact us at support@vremi.com or (646) 490-9904, and we will do our best to resolve it for you.
This manual is to be used with all items with the model numbers
WARNING: Keep all plastic bags away from children.
VRM050659N
(646) - 490 - 9904
vremi.com/chat
CHAT WITH US CALL US
EMAIL US
Warranty
Warning
Drop Us A Line

Table of contents
Popular Sport & Outdoor manuals by other brands

Moultrie
Moultrie Feeder Feet Gen2 instructions

Strong Enterprises
Strong Enterprises 311 Wedge owner's manual

TP Toys
TP Toys TP active fun TP253 Instructions for assembly maintenance and use

AluSport
AluSport TPI380V quick start guide

Jaypro Sports
Jaypro Sports N24GB Installation and maintenance manual

Enabling Technologies
Enabling Technologies DYNAMIQUE Initial Assembly