Watermark 22-FS User manual

06/15/2021
Page 1 of 7
WATERMARK DESIGNS, LTD. 350 DEWITT AVENUE BROOKLYN, NEW YORK 11207
© 2019 WATERMARK DESIGNS, LTD. ALL RIGHTS RESERVED.
INSTALLATION INSTRUCTION
Floor Mounted Bath Spout
22-FS/23-FS/22-FSG/23-FSG

ROUGH-IN DIMENSIONS
06/15/2021
Page 2 of 7
WATERMARK DESIGNS, LTD. 350 DEWITT AVENUE BROOKLYN, NEW YORK 11207
© 2019 WATERMARK DESIGNS, LTD. ALL RIGHTS RESERVED.
22-FSG/23-FS

ROUGH-IN DIMENSIONS
06/15/2021
Page 3 of 7
WATERMARK DESIGNS, LTD. 350 DEWITT AVENUE BROOKLYN, NEW YORK 11207
© 2019 WATERMARK DESIGNS, LTD. ALL RIGHTS RESERVED.
22-FSG/23-FSG

06/15/2021
Page 4 of 7
WATERMARK DESIGNS, LTD. 350 DEWITT AVENUE BROOKLYN, NEW YORK 11207
© 2019 WATERMARK DESIGNS, LTD. ALL RIGHTS RESERVED.
PART BREAKDOWN
22-FS/23-FS

06/15/2021
Page 5 of 7
WATERMARK DESIGNS, LTD. 350 DEWITT AVENUE BROOKLYN, NEW YORK 11207
© 2019 WATERMARK DESIGNS, LTD. ALL RIGHTS RESERVED.
PART BREAKDOWN
22-FSG/23-FSG

06/15/2021
Page 6 of 7
WATERMARK DESIGNS, LTD. 350 DEWITT AVENUE BROOKLYN, NEW YORK 11207
© 2019 WATERMARK DESIGNS, LTD. ALL RIGHTS RESERVED.
NOTICE AND DISCLAIMER
TO KEEP THE QUALITY OF THE TUB FILLER PLEASE FOLLOW THESE
INSTRUCTIONS
•Rinse the tub filler with water.
•DO NOT use any cleaning agents containing abrasive or coated abrasive materials.
•DO NOT use any cleaning agents containing acids, polish abrasives, or hard cleaners or
soaps.
IF TUB FILLER REQUIRES REGULATORY OR HEAVY CLEANING, THE
FOLLOWING PROCEDURES ARE RECOMMENDED
1. Clean the tub filler with water.
2. Remove tough surface film and build-up with: SOFT liquid cleaning agents or clear
liquid glass cleaners; non-acidic, non-abrasive gentile liquid; fully dissolved powder
cleaners mixed according to the manufacturer’s directions; or non-abrasive liquid
polishers.
3. After cleaning, make sure to fill sufficiently with clear water to completely remove
remaining cleaning agents. Then dry with a soft cotton cloth.

06/15/2021
Page 7 of 7
WATERMARK DESIGNS, LTD. 350 DEWITT AVENUE BROOKLYN, NEW YORK 11207
© 2019 WATERMARK DESIGNS, LTD. ALL RIGHTS RESERVED.
INSTALLATION STEPS
1
•Select a location for the floor spout. Make sure it is at least 11”away from any walls or fixtures.
•Install a ¾-14” NPT female adaptor to the supply line. Make sure line is properly strapped.
•Female adaptor must be recessed by 1/8” from the top of the floor surface.
•Maximum hole size for supply is 2”.
2
•Screw in the bottom thread of the bath spout into the supply.
•Align the bath spout to the desired direction.
•Thread the base of the bath spout by turning it clockwise until it pinches the floor.
•Using the four holes on the base as a guide, drill 4x pilot holes for the wood screws.
•Screw the 4x screws into the holes to secure the bath spout