USER’S MANUAL
Decorative Laser Light Projector
Code: PROJ-LSR-RG8-WL
CAUTION! Performance of procedures other than those specified herein may result in
hazardous radiation exposure.
This laser is certified as a class II laser product to the requirements of the US federal laser
product performance standard (FLPPS) Contained in the regulation in 21 CFR sub-chapter j.
Class II laser products can be hazardous when directly viewed.
Avoid direct viewing of class II laser energy. For reference the FLPPS requirements for
demonstration laser products like laser pointers are limited to class II levels of laser energy.
This product uses diffractive optics to scatter the beam energy. This scattering effect causes
the energy concentration to drop below the exposure limits for momentary or accidental
viewing at a relatively short distance from the laser aperture. As similar with all bright light
sources, when you operate this device in unsupervised general public areas, it is
recommended that up-close access to the outdoor laser be restricted of prevented. This laser
display device incorporates a class II laser system which, by itself, maybe hazardous However,
this laser display device incorporates a protective housing and diffractive holographic optics in
the machine’s design such that there is no exposure or human access to the laser radiation
during operation or maintenance above the class ii limits, Each individual laser beam’s power
is less than 5mw, Which is about an average laser pointer.
Warning! Under no circumstance shall attempts be made to open the protective
housing or operate the device if the aperture windows are damaged. All service to this
laser display device requiring the protective housing to be opened and /or removed
shall be performed by a outdoor laser service personal or their authorized agents. No
user-serviceable parts-opening the outdoor laser protective housing voids the warranty.
Changes or modifications to this equipment not expressly approved by the party responsible
for compliance could void the user’s authority to operated the equipment. This device complies
with Part 15 of CE&ROHS Rules. Operation is subject to the following two conditions:(1) this
device may not cause harmful interference, and(2) this device must accept any interference
received, including interference that may cause undesired operation of the device.
