When in the installed position the mains
plug must be accessible for disconnection.
Do not use manual stabilizer
Electric Shock Hazard
Electrically earth this appliance.
Do not use an extension cord or a portable
electrical outlet device.
Failure to follow these instructions can
EARTHING INSTRUCTIONS
This washer must be earthed. In the event
of a malfunction or breakdown, earthing will
reduce the risk of electric shock by providing
a path of least resistance for electric current.
This washer is equipped with a separate earth
wire. The earth wire must be connected into
an appropriate outlet that is properly installed
and earthed in accordance with all local codes
and ordinances.
IMPORTANT : Improper connection of the
equipment-earthing conductor can result in a
risk of electric shock.
Whirlpool Corporation declines any respon-
sibility for damage caused by failure to
observe this rule.
if you are in doubt as to whether the appliance
is properly earthed.
Do not modify the plug provided with the
electrician.
WATER SUPPLY REQUIREMENTS
more than 1 m from the rear side of the
Washer and at a height of at least 1.3 m
from the foot level.
If connected to hot water supply, ensure
that the temperature does not exceed
70oC. It may cause a fault or damage to the
machine.
The water storage tank should correspond
to a level of 2 to 80 m above the level of tap
2
In case of
inadequate
water pressure,
customer has
to correct the
water supply to
or pour water
manually.
Suggestion to
Tank height from water inlet tap should
Ensure that there is no blockage in water
line.
FLOOR REQUIREMENTS
Installing on a carpet is not recommended.
Floor must support the washer’s total weight
(according to plumbing laws), where the
washer is installed. This will ensure draining
the washer due to malfunction or hose leak.
Do not place the machine on a slanting,
uneven or unstable surface.
Place the machine on a solid leveled surface
to avoid excessive vibration and noise
during operation.
Installation Procedure
Before you start:
Parts removed during installation like
screws, inlet valve plug, etc. must be
disposed properly.
It is necessary to remove all shipping
materials for proper operation and to avoid
excessive noise from the washer.
