Wilson Electronics 901135 User manual

Installation
Guide
Corner Wall Mount
for Panel Antenna
Part # 901135

Use the1.
mount itself
as a guide to
draw on the
wall where
you want
your screws.
Installing the Corner Bracket Mount
for Panel Antenna
Use the1.
mount itself
as a guide to
draw on the
wall where
you want
your screws.
asfds1.
asdfa1.
Attach the mount to the wall,2.
using a screw driver.
asfds1.
asdfa1.
Attach the mount to the wall,2.
using a screw driver.
Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660 or
email: [email protected]. Hours: 7 am to 6 pm MST.
Note: Use the mounting hardware (screws,
washers, anchors) that came with your
panel antenna to install this product.
Installing the Corner Bracket Mount
for Panel Antenna

Installing the Corner Bracket Mount
for Panel Antenna
Use the1.
mount itself
as a guide to
draw on the
wall where
you want
your screws.
asfds1.
asdfa1.
Attach the mount to the wall,2.
using a screw driver.
1.
2.
3.
Attach4.
the Panel
Antenna to
the Corner
Bracket
Mount.
Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660 or
email: [email protected]. Hours: 7 am to 6 pm MST.
1.
2.
Use a screw driver to loosen the3.
two sides, move the two sides to the
desired angles, then re-tighten the
screws.
1.
2.
Use a screw driver to3.
loosen the two sides,
move the two sides
to the desired angles,
then re-tighten the
screws.
1.
2.
3.
Attach4.
the Panel
Antenna to
the Corner
Bracket
Mount.

3301 East Deseret Drive,
St. George, UT 84790
For additional Technical Support visit
www.WilsonElectronics.com
or email at: [email protected]
Phone: [phone]
Local: 435-673-5021
Fax: [phone]
www.twitter.com/WilsonCellular
www.facebook.com/WilsonCellular
103069_Rev2_061311