X-Vision TP12 A Series User manual

4. Specifications
CCTV CCTV
TECHNICAL SUPPORT:
For Technical Support for any Xvision product please contact your local distributor.
LIMITED WARRANTY:
This product is supplied with a 1 Year warranty.The Warranty excludes products that have been misused,
(including accidental damage) and damage caused by normal wear and tear. In the unlikely event that you
encounter a problem with this product, it should be returned to the place of purchase.
Models: TP1210A / TP1220A
12V DC 9 output 10A / 18 output 20A,
Professional Wall Mount Power Supply
Manufactured exclusively for Xvision
Model:
TP12xxA Series
12V DC PTC fused protected outputs,
Professional Wall Mount Power Supply
Before you begin
•Power to the unit should be correct for local electrical appliance standards & regulations.
•
Ensure the AC Input power is off before working with the unit.
•The Unit will supply a constant voltage to all Output contacts as specified. Each Output
is protected with a PTC fuse, this will auto reset and stop any short circuit causing
damage to the device. The fuse will auto reset, note: All other Outputs will be
unaffected.
•The unit is protected against reverse polarity and fuse fault. Should the common supplied
output be short circuited, the unit will drop the voltage until the fault is corrected. It will
immediately reset the voltage when the fault is removed. The same applies when
exceeding the Current specification.
Model: TP1210A TP1220A
Input Power: 120 / 240V AC @ 50/60Hz
Output Power: 12V DC
Total Output Current (Max): 10A 20A
Output Current (Max) per port:
Fuses Rating at: 2.5A for each port, however max current cannot exceed the total
capacity of units rating.
Main Fuse Rated at: 250V 3A
Mounting: Wall
Weatherproofing: No
Dimensions: 187 x 226mm 281 x 255mm

1. Product Description
The TP12xxA features individually PTC fuse protected 2500mA, with
maximum output current limiting & over voltage protection. This well
designed unit is easy to install & provides a professional solution for power
distribution in all types of CCTV installation.
3. Installation
1. Mount the Power Supply case at the required location. The case has clear
fixing hole locations, which are easily accessible.
2. Ensure the local power AC is not live before any connection is made.
3. Connect each camera to the individually protected outputs as desired.
2. Product Assembly
NOTE: •Green plug you removed to provide easy connection of cables.
•Cables ties can be used to secure down the output cables to case
for protection of accidental pulled cables disconnecting.
4. Remove the master AC input power fuse located top left.
5. Now connect the AC input power colour coding which matches
local standards. Product is designed for direct ring mains
connection for the most secure power source, ideally a fused spur
would provide the best source for the AC power input for device.
Blue = Neutral, Green = Earth, Brown = Live
Left Side Front Inside
Holes to fasten unit to wall
Push out metal to install PG
connectors if required.
Cable Tie lungs
Top View
Right Side