Zaor MIZA V User manual

PAG 1
MIZA V - Stand

Here is a general instruction on how to use the furniture assembly kits:
1) Insert and screw in the system bolt(s) into the socket(s) already present on the part(s) making sure the hole is at 90º from the edge
2) Insert the excenter(s) into the round holes on the part to be joined, aligning the hole(s) on the side with the axis of the bolt(s)
3) Assemble the connecting parts,inserting the bolts into the smaller holes in the connecting part, the bolt tip fitting into the side hole
of the excenter until the hole in the bolt and the center hole of the excenter align
4) insert the locking screw into the excenter, and tighten with a cross screw driver all the way without using force!
Thank you for choosing a piece of Zaor studio furniture,
which will hopefully make your life easier, more ergonomic and improve the looks of your workspace.
Before you can enjoy the comfort of your new acquisition you need to assemble it.
We have tried to give you as much detail as needed and as little as possible.
Should you run into any difficulty with this assembly you can get in touch with us via
[email protected] to set up a Skype session or phone call.
Excenter with 2 holes
System bolt with hole Locking screws

PAG 3
12
M 6x40
3
4
5

Assembly Manual
ZAOR Studio Furniture SRL | Tel: [phone] | Email: [e-mail] | Web: www.zaorstudiofurniture.com
Materials used:
particle board;
metal assembly kits.
PACKING LIST
4x M6x 40 screws;
5 assembly kits.
Instructions for use and cleaning
- clean with a soft cloth, slightly humid or speci
products for wood or lacquer;
- avoid the use of abrasive cleaners