Calibre 520
Automatic Movement Operation Manual
Automatic watches can be used only by those who are reasonably active as the automatic
winding relies on a regular movement of the wrist. The watch must be given an initial manual
wind of 8 to 10 turns and provided that it is worn on the wrist for a minimum of 8 hours each
day it will continue to function indefinitely and may be taken off the wrist for a maximum period
of 30 hours. If this period is exceeded the movement will stop and another manual wind will be
necessary. It must be remembered that when worn in bed the movement of the wrist is
insufficient to operate the automatic winding.
Time Stand Accuracy
1) 21,600 beats per hours
2) Accuracy between -30 to +30 seconds per day worn under normal conditions.
Page 1
Water Resistance Table
Level of
Water
Resistance
Suitable for
Everyday
use
Can
withstand
accidental
splashing
Suitable for
Swimming
Suitable for
Pool Size
Suitable
for
snorkelling
or water
sports
Suitable for
high board
diving or sub-
aqua diving
None Yes No No No No No
3 ATM
(30m/
100ft
Yes Yes No No No No
5 ATM
(50m/
150ft)
Yes Yes Yes Yes No No
10 ATM
(100m/
300 ft)
Yes Yes Yes Yes Yes No
Water resistance is not permanent. In the course of time, the gaskets of the case and
crown may become worn and reduce the water resistance of your watch. We recommend
the periodic checking
Normal Crown – always make sure it is pushed fully into case
Screw down Crown – tighten screw down crown completely to screw lock position.
To maintain water –resistance crystal, crown and case must remain intact
Exposure to Salt Water
If your watch is designed for sports or working in the water and it becomes exposed to salt
water or significant amounts of perspiration, it should be rinsed in fresh water and dried
thoroughly with a soft dry cloth.
Important
Buttons must not be operated while in contact with water
Page 2
Functions
- Hours
- Minutes
- Seconds
- Day of the week dial
- Date of the Month and Month
- 24 hours dial
- Manual Year dial
- Water Resistance – Check the back of the watch and refer to the Table.
Important
•Do not set the day & date between 06.00 PM and 06.00 AM, as this may cause
damage to the movement.
•At the end of the each month the date is required to be changed manually.
Instructions for Day, Date, Month & Year Setting
1) To achieve an accurate day of the week setting, unscrew the crown and pull the
crown out to first position and turn the crown anti-clockwise until a day prior to
the day you require is achieved i.e. if today is Wednesday then set it onto
Tuesday.
2) Now turn the crown clockwise until a date prior to the date you required is
achieved. i.e. today is the 16
th
then set it onto the 15
th
.
3) Unscrew button A and press until correct month is achieved.
4) Unscrew button B and press until correct year is achieved.
Page 3
Instructions for Time Setting
1) Unscrew the crown and pull the crown out to second position and turn the crown
anti-clockwise until the day of the week is correct. The day and date will now be
corrected, now set the time but make sure the time is set onto am or pm.
2) The 12/24 hour dial will indicate AM or PM.
3) Finally push and screw both the crown and buttons into Normal Position.
Page 4
Calibre 520
IN1612
Page 5
