A&B Home HYDRIAN Operation instructions

Assemble Instruction
PREPARING THE PUMP
Locate the pump kit enclosed in with the The kit
contains 3 threaded connections, small , medium,
and large. Select the smallest diameter connector
and screw that firmly into the pump body.
PREPARING THE FOUNTAIN SPHERE TOP
Unpack the fountain’s top sphere and gently turn it
over to locate the pre attached tube on the underside.
Check to insure that the valve is open {shown in
red- open is parallel to the tube}.
A&B Home Inc. - HYDRIAN Outdoor Garden Fountain MFG # D69518
IMPORTANT Our fountain has been designed for easy assembly.
Approximate time to assemble- Two people less than one hour.
ASSEMBLY OF
PEDESTAL TO TOP BASIN
Carefully unpack both the fountain pedestal and the
top basin and place both pieces in an open area that
has plenty of room to assemble these pieces together.
With 2 people lift the top basin and center it over
the top of the pedastal and gently lower it so that
the opening in the bottom of the basin sits on the
top of the pedestal. Once basin is sitting on pedestal
gently rotate the basin clock-wise to lock the two
pieces together.
Instruction pg. 1 of 3





POSITION PUMP, PLUG, AND CORD
TO THREAD THROUGH PEDESTAL
Locate the recessed indentation on the inside of the
top basin and position the pump as shown with the
connector pointing upwards. Drop the plug through
the pipe in the center as shown and thread the cord
through the pedastal and pull the plug through the
opening at the base of the pedestal. After the cord
and plug are correctly postioned, use the provided
plastic cap to cover the tube and lock the pump cord
in place as shown
FINAL STEP-CONNECTING
FOUNTAIN BALL TOP TO PUMP
AND FINAL POSITIONING.
Carefully place the top fountain ball on its side in
the basin so that you can access the pre-attached
tube. Take the open end of the tube and push it
firmly onto the connector on the top of the pump.
Using the included screwdriver, tighten the clamp at
the base of the pre attached tube to secure it firmly
to the connector on the pump.
Place the fountain in position in your garden or
landscape and with the included cord cover, position
as shown.
Instruction pg. 2 of 3


For questions and inquires on this item,
please contact Customer Service at A & B Home.
Email - [email protected]
Telephone - 1 888 868 1808

IMPORTANT 
Check and adjust water level periodically,
Due to evaporation, clean water must be added periodically.(check weekly or
more often depending on your climate) Failing to do so,could cause the water
pump to run dry, resulting in a damaged pump. Damage to the water pump due to
an inadequate water level in the fountain base will void the limited warranty.
WARNING 
NEVER REMOVE THE GROUND PIN FROM THE ELECTRICAL PLUG. FOR YOUR
PROTECTION, ALWAYS UNPLUG THE PUMP UNIT FROM ITS POWER SOURCE
BEFORE INSTALLING OR SERVICING YOUR FOUNTAIN.
SHOULD THE UNIT APPEAR TO NOT BE WORKING PROPERLY, DO NOT REACH
FOR, REMOVE, OR DISASSEMBLE THE PUMP BEFORE YOU DISCONNECT THE
POWER.
Instruction pg. 3 of 3
Remember to make sure the plug is dry and clean before inserting into the outlet.
When having trouble with the water flowing evenly from the ball to the basin, or
in the event you need to level the surface of your fountain, use the included shims to
even out the water flow. To use the shims, place the shim{s} underneath the base
opposite the side that that is not flowing evenly. Once shim{s} are in postion break
them off at the crease and this will hide the shim but keep the fountain level.
In the pump box is a detailed instruction book showing how to adjust pump flow and general
maintenance. KEEP THIS FOR FUTRURE REFERENCE.
For safety always use a properly grounded outlet.
NOTES 