EasyPro Tranquil Décor HBB39 User manual

HBB39 Bamboo fountain includes
Vertical basalt column Faux bamboo spout
Lower polished stone Tube of black silicone
Complete kits will include these items as well as
basin, plumbing kit and pump.
HBB39 Bamboo Fountain Tubing and Spout Installation
1To connect plumbing to the basalt, lay the basalt on its side. Be sure to be careful when
moving the basalt. Use assistance if needed to
avoid injury.
2
The bottom hole needs to be sealed by tubing
or other method so water will travel up the
column and out the side port and bamboo
spout. An EasyPro plumbing kit part # PK1L
includes 3/4” tubing and a friction ring that will
seal this hole.
5Once tubing is connected, the column can be tipped into place on the basin and connected to
the pump.
4Carefully press the assembled friction ring (4A) and tubing into the bottom hole of the basalt.
It will be a very tight t. The use of a dull object
(i.e. unsharpened pencil) can be used to help
press the friction ring into the hole. (4B)
Press until friction ring is below the surface of
the basalt. (4C) Avoid breaking or tearing the
friction ring or water will not travel properly up
the column.
by
Tubing Installation Instructions
3
With the PK1L tubing kit, install the friction ring
over the end of the tubing.
4C4B4A
friction ring
Thank you for your purchase of the Tranquil Décor
Bamboo Basalt Fountain from EasyPro. Please read
through all instructions before beginning assembly
of your fountain.

[phone] • Grant, Michigan • www.easypro.com 9884 • 4/19
For more information
A video of a similar basalt installation can be seen
at our website in our videos section or our YouTube
channel here: https://youtu.be/13YG3I5c3yY.
3 Dry t the bamboo spout into the hole on the column’s side and mark the placement with
a pencil.
4
Remove the bamboo spout and use supplied
silicone (or other silicone if black color is not
preferred) by applying it to the spout. Use the
line drawn as a guide to apply silicone just inside
the line about 1/4”. This will allow the silicone to
spread just a little when installing the bamboo
but not make a mess on the outside of the stone.
Bamboo Spout Installation
2If you wish to shorten the bamboo spout, it can be cut down to your desired length.
1
Determine where the column and lower stone
will be placed. Provided the ow is 300 gph or
less, water will arch only a few inches as it drops
down.
5Install the spout into the side hole. Be sure the spout is in the correct orientation so water will
properly spill from the spout.
6Carefully apply a bead of silicone around the base of the spout. Use only enough to seal the
gap. If you wish to smooth the surface of the
silicone, do so right away as it will skin over in 5
to 10 minutes.
7Allow silicone to fully dry before putting fountain into use. A full cure takes about 24 hours. If any
leaks around the spout occur, simply use a little
more silicone to seal them up.