AAP SP-1 User manual

SPECIFICATONS
292 mm(11.5 Inch)
204(8.03Inch)
SP-1 LOUDSPEAKERS OWNER’S MANUAL
Frequency Ranges: 70Hz – 20kHz (±3dB)
Recommended Amplifier Power Range: 20 – 100 watts
Sensitivity: 88dB
Nominal Impedance: 4Ω
Low-Frequency Drivers: 5"x1
High-Frequency Drivers: 1"x2
Dimensions (H x W xD): 204x292x113 mm
8.03x11.5x4.45 Inch
Weight: 7.7 lbs /3.5 kg
All features and specifications are subject to change
without notice.
113(4.45 Inch)
CONNECTIONS
Connect Speaker To Amplifier
Be sure to turn off your Amplifier before connecting or disconnecting speakers.
Do not operate the speaker with power exceeding limitation,or it may damage the speaker.
AMPLIFIER OUT
Left
Right
You may choose one of the following three ways to connect the cable with speaker terminal:
Speaker Cable Options
C. Connect With Y Plug
B. Connect With Banana Plug
A. Connect With Speaker Cable
Twist axial wire
10mm

Warranty & Service
The SP-1 speakers come with warranty period of 3 years, starting from the date of purchase. This
warranty is provided to original owner, and covers defect in materials or workmanship that occurs
in normal use. This warranty excludes damage that results from abuse, mis-use, accidents, shipping,
or repairs or modifications by anyone other than authorized representatives. The warranty
is void if serial number has been removed.Should you need service on your speakers, please bring
it to the dealer whom you purchased from along with sales slip.
If this is not possible, call or write to:
American Acoustic Development LLC
8509 MID COUNTY INDUSTRIAL DRIVE,
ST.LOUIS MO 63114. USA
Tel: [phone]
Fax: [phone]
www.philjonespuresound.com
[email protected]
The Mountings
Wall mounting illustration
206 mm(8.1 Inch)
SP-1 LOUDSPEAKERS OWNER’S MANUAL
The SP-1 speaker is designed to be mounted on a wall. Each speaker has four keyholes in the
rear to allow either left- or right-side placement. Each speaker will require two 1-1/2" (38) #4 wood
screws fastened to a wall stud. If a wall stud is unavailable, install an anchor appropriate for a 1-1/2"
(38mm) # 4 screw. Use the supplied template to accurately position the screws on the wall. Refer
to the diagrams below for more assistance.