Able Planet LINX AUDIO NC200 User manual




Able Planet is a company founded on the
principles of hearing preservation, enhancement
and superior sound performance. The company
is committed to the development of innovative
audio and communication devices for people
with All Levels of Hearing™. The secret behind
the advanced sound quality is a patented
technology called LINX AUDIO.™ Originally
developed for a new generation top-of-the-line
hearing aids the LINX AUDIO™ technology
alters the audio signal to increase the intensity
of higher frequency harmonics. This makes it
easier to hear words, music and sounds. The
enhanced audio signal also increases the
perception of loudness without increasing
volume, providing full rich sound at lower
volumes. Imagine being able to listen longer,
fuller at lower volumes.

Noise Cancelation – What to expect:
Able Planet Noise Canceling headphones sample
the exterior noise and the circuitry will suppress
the noise as it is transmitted via the internal
speakers/headphones. What could be heard
without a source being played is the active noise
canceling attempting to suppress background
noise. When no signal is present (a song being
played) the NC circuitry will generate a minimal
amount of white noise. However, once a signal is
engaged, this noise should be completely
eliminated and all that should be heard is music or
the audio source.
Sensitivity at 1kHz is 115dB (Off); 121dB (On)
Frequency Response: 20hz to 20kHz

How to fold for Storage or Travel:
On the top of the headband is an arrow, the
headband has a hinge and snaps apart the
direction of the arrow. Hold the headband with the
arrow facing you. Gently put your thumb on either
side of the arrow and push away from you. The
small latch under the arrow will open. When the
headphones are in shape of a crescent, then you
can fold them down and fold the ear cups toward
each other.
Where to place the cord
On the bottom of the left ear cup is a large hole
where the large end of the in-line volume control
cord can be connected to the headphones.
NOTE: This is a very snug connection and if the
cord is not fully pushed in (flush with the ear cup)
you will not get sound from the headphones.

Battery Placement:
The battery compartment is located behind the
headband arm on the top of the right ear cup. Tilt
the right ear cup in to locate the compartment.
Pull down the small latch at the top of the
compartment to unlatch the door. Battery should
be installed with the negative side up.

ADDITIONAL NOTES:
The noise cancelation feature will work with or
without source plugged in.
The headphones will work with our without the
noise cancelation feature on.
Battery life is around 30 hours
Length of cord – 5 Foot
Airline Adaptor: Most airlines are using standard
headphone plugs so a two prong adaptor is not
necessary – this product should work with the
need for an adaptor.