ABLE2 SHO-ME 30.3504 User manual

02-10-09
ELECTRONIC SIREN
Model 30.3504
Made in the U.S.A
Local and International Numbers
Phone: [phone] Fax: [phone]
U.S. and Canada Toll-Free Numbers
Phone: [phone] Fax: [phone]
Installation Manual
Black
Red
Ground
Other quality products manufactured by SHO-ME ®
Speakers; LED Lights; Strobe Lights (Directional and 360°);
Headlight Flasher Kits; Full size LED Light Bars; Mini LED Light Bars;
Mini-Bars; Custom Switch Panels; Spot and Flood Lights;
6 Volt Rechargeable Lights; Map Lights; Megaphones;
Accessory Outlets and many
more Components and Accessories.
PRODUCTS COMPANY
P.O. Box 543 ● 804 E. Hwy 248 Cassville, Missouri 65625-0543
+12 Volt Positive
100 Watt
Speaker
2 Conductor Wire
WIRING DIAGRAM
SHO-ME®

02-10-09
ELECTRONIC SIREN
MODEL 30.3504
INTRODUCTION
The 30.3504 siren consists of an amplifier which powers
one 100 watt RMS speaker.
The 30.3504 siren system contains 2 ON/OFF push button
switches and 2 momentary push button switches. This siren is
capable of producing four sounds commonly known as WAIL,
YELP, PHASER, and AIR HORN. Any of these four sounds may
be selected by pressing the appropriate button.
INSTALLATION OF POWER AMPLIFIER
Select a location suitable for installation of the amplifier.
This area must be free from moisture, heat, and abuse. Take
special care to be certain the siren is not mounted in the
deployment area of the air bag! Using the mounting bracket as a
template, mark the location of the mounting holes. Drill holes at
these locations to assist in starting the mounting screws provided.
Mount the bracket, then mount the siren to the bracket using the
screws and washers supplied. All installations are the sole
responsibility of the buyer.
SPEAKER CONNECTIONS
Use only one 100 watt speaker with an 11 ohm
impedance. Route the 16-2 speaker wire from the siren, to the
front of the car to the speaker. Be careful to protect the wire from
abrasion and cuts as it passes through the firewall and other
potential problem areas. Cut off any excess wire, and connect to
the speaker terminals.
POWER INPUT CONNECTIONS
Connect the black wire from the siren, to a convenient and
solid ground (-). Connect the red wire to a positive (+) voltage
source capable of supplying 20 amps. To protect the wiring
going to the siren, install an in-line fuse or circuit breaker on the
end of the wire as close to the positive source as possible. The
current draw of the siren during operation is approximately
8 amps, when supplied by 13.8 volts. The current draw of the
siren when power is applied, but no functions are selected is
approximately .03 amps.
WARRANTY
Merchandise returned under warranty shall be subject to
factory inspection and repaired, replaced, or credited at Able 2
Products Company, Inc.'s option. Water, condensation, or
negligence will VOID warranty. This unit's warranty period is for
2 years parts and labor.
OPERATION
By depressing the push button switch marked "WAIL", that
sound will be produced and the "WAIL" indicator light will come on.
Likewise, depressing the push button marked "YELP", that sound
will be produced and the "YELP" indicator light will come on. Any
time the "PHASER" or "HORN" button is depressed, that sound
will be made, and the proper indicator light will come on. These
sounds will over-ride either the "WAIL" or "YELP" functions.