Vixen Horns VXS7920 User manual

VXS7920
INSTALLATION GUIDE
PAGE 1 of 3
BEFORE BEGINNING YOUR INSTALLATION
Read through the instruction guide before getting started with the installation. Professional installation is recommended for
this product.
CONTENTS
18-Sound Control Box
100W Speaker
Bluetooth Remote Control/Microphone with Holder
Lighter Plug with USB Cable
8-PIN Power/Speaker Wire Harness
5-PIN Lighting/Horn Control Wire Harness
15A Spare Fuse
Mounting Hardware
SAFETY INSTRUCTIONS
Make sure you never attempt to disassemble this horn kit’s electrical components.
Avoid operating this product in an area with risk of falling or submergence into a liquid (water).
Make sure you set up in areas with good ventilation.
Never sound the air horn anywhere near your ear(s) or that of another person.
Make sure your battery ground is detached before getting your installation started.
Employ equipment for eye protection during drilling operations.
Do not replace your vehicle's factory horn with this unit or use it as a warning device.
The specific voltage requirement for this horn kit is 12 volt DC, therefore installation must be done to a DC power
source of 12 volts.

VXS7920
INSTALLATION GUIDE
PAGE 2 of 3
MOUNTING
CONTROL BOX
Find a mounting location in which you will have access to the buttons and connectors of the control box. Ideal
locations are driver compartment, firewall, under the seat. IMPORTANT: Do not mount the control box in the
engine compartment or in a place that will obstruct any of the vehicle’s air bags deployment.
Mount the unit on the location chosen with the four screws provided.
SPEAKER
The ideal location for the speaker to be installed is a dry area inside your engine compartment where it will be
safe from exhaust and engine manifold heat.
To make the speaker firm and secure use the mounting bracket as a template to mark the holes location and
drill using a 1/8" drill bit.
Secure speaker with four self-tapping screws (not provided).
IMPORTANT: The downward orientation of the speaker will prevent water to get inside.
ELECTRICAL CONNECTIONS
SPEAKER CABLE (GREEN): Route both cables through the fire wall of your vehicle to attach it to the
speaker previously installed in the engine compartment.
POWER CABLE (RED/BLACK): Connect the positive wire (Red) to a power source in the vehicle that only
gets power when the vehicle’s ignition is on. Recommended connection points are: windshield wiper motor,
blower motor or an accessory terminal on the fuse panel. Use a 5A fuse (not provided) on this connection for
circuit’s protection. Connect the negative wire (Black) to ground, any rust and paint free metal body bolt or the
negative (-) battery post.
LIGHTING CONTROL: Yellow cable is connected to the 12V power source and White cable to the positive
terminal of your light (Repeat this step with the other Yellow and White cable if you are controlling a second
light).
VEHICLE HORN CONTROL: Connect the Blue cable to your vehicle’s horn switch if you want to control your
vehicle’s horn with the remote control.

VXS7920
INSTALLATION GUIDE
PAGE 3 of 3
OPERATION
To start using the electronic horn set the vehicle's ignition to the ON position.
ON/OFF: Turning the SWITCH located in the control box to the ON position will turn on the control box and
set it on SLEEP mode.
BLUETOOTH REMOTE CONTROL
PAIRING: Using the USB cable provided connect the remote to the USB port in the control box. Press the
ON/OFF button located in the remote to turn ON the remote, wait a few seconds and then turn off the remote
and control box. To complete the pairing process turn ON again the control box and the remote.
CHARGING: Using the USB cable provided connect the Bluetooth microphone to the USB port in the control
box or to the lighter socket. If using the lighter plug connect this one to a 12V outlet in your vehicle. “RIO”
button in the remote will light up RED.