ABOX 43249-61259 User manual

User Manual
Digital Tyre Inflaror
Digital Durable Fast
4
Please resd the manual carefully before using the product

Notes:
1. Please start car engine before inflating to
assure the unit has enough power.
2. Please check your tire pressure specifications
before inflating.
3. Please don't bend air-pipe while inflating.
4. Please cool down the unit for 15 minutes
after 20 mins sustained work or if any abnormal
sound or excess temperature happened.
5. The operator should always pay a close
attention while inflating.
6. The product should avoid damp, hard fall,
flood and sediment immersion.
7. DC motor may produce EDM electric sparks
while working. Please don't place near
flammable liquids or gases.
1

Specif
ications：
Rating Voltage
Gauge Accuracy
Rating Power
Max Current
Cable Length
Hose Length
Ambient Temp
Storage Temp
Product Size
Net Weight
DC-12V
220Z±15KPa
120W
10A
300±10cm
50±2cm
-20℃~+60℃
-30℃~+70℃
17×15×6.7cm
0.75Kg
1. Please start car engine before inflating to
assure the unit has enough power.
2. Please check your tire pressure specifications
before inflating.
3. Please don't bend air-pipe while inflating.
4. Please cool down the unit for 15 minutes
after 20 mins sustained work or if any abnormal
sound or excess temperature happened.
5. The operator should always pay a close
attention while inflating.
6. The product should avoid damp, hard fall,
flood and sediment immersion.
7. DC motor may produce EDM electric sparks
while working. Please don't place near
flammable liquids or gases.
2

Product Introduction:
Pressure gauge
Power switch
LED light Light switch
Air pipe
Charging Cable
Needle Inflating Nozzle
3

Operating Instructions:
1.Start the car engine
2.Insert 12V DVplug into the
cigarette light socket
3. Connect the Air-pipe to the tire
valve and it will gauge your car tire
pressure automatically.
4.Turn the inflator On. It will
automatically stop when reaching
the target value. The normal tire
pressure is 30-35psi. You can
press “M” key to set your desired
pressure.
5.Press the power button to start
inflating, it will automatically stop
when target value reaches.
6.Turn off the power, disconnect
the air hose nozzle and pull out
power plug from socket.
*Three modes of LED light:
Press once--lighting
Press twice--flashing warning
Press thrid--SOS lighting
4

1. To change measuring units:
Short press "M" key to change to bar, kPa, psi,
kg/cm² and up arrow, down arrow. The unit
should be flashing. Hold "M" key for 2-3
seconds to set the unit.
2. To set the pressure:
Short press "M" key until the up or down arrow
flashes then hold it 2-3 seconds to set it. Short
press "M" key again to add or reduce the
pressure value. The value should be flashing. To
set the value, wait 3 seconds and it will stop
flashing.
3. Quick setting:
Hold "M" key 2-3 seconds to enter quick
setting. The default 35 pressure value should be
flashing. Short press "M" key to add or reduce
the pressure value. To set the value, wait 3
seconds and it will stop flashing.
Digital pressure gauge operation instruction：
5

@2018 abox-tech.com All Rights Reserved.