ACRITEC 08014 Mounting instructions

Bath Pillows
Use Manual
Important
• Thoroughly inspect your product before proceeding with the use
Caution
• Read all instructions carefully before use
• Save this manual for future reference.
In keeping with our policy of continuing product improvement, Acritec Industries Corp. reserves the right to
change product specifications without notice.

Installation:
• Clean and dry the bathtub surface.
• Remove the protective film from the back of the pillow.
• Apply the pillow gently in the desired position, pressing from the
center towards the edges to help remove air pockets.
Removal & Repositioning:
• Gently pull on one end of the pillow to slowly peel it from the
bathtub. Use water as necessary to ease removal.
• Cover the adhesive surface with plastic wrap after removal. This will
keep it free of dust and debris.
• Should the adhesive surface lose it’s tackiness, reactivate it by
rinsing the surface with fresh water and allowing it to air dry.
Care and Maintenance:
• Wash with water and diluted liquid dish soap as necessary. Place
the pillow with the adhesive side up and allow it to air dry.
• To store the pillow, apply plastic wrap to the adhesive surface.
• Using the pillow with essential oils, bath salts, or strong detergents
will shorten its lifespan.
• Avoid prolonged exposure to UV rays as this may cause
discoloration.