TRIBU D2160 Series User manual

T-Table
ASSEMBLY INSTRUCTIONS
D2160-x-x / D2161-x-x
D2162-x-x / D2163-x-x
D2164-x-x / D2165-x-x
D2166-x-x / D2167-x-x
D2168-x-x / D2169-x-x
D2170-x-x / D2171-x-x
D2172-x-x / D2173-x-x
D2174-x-x
TT05 - 10-08-2022
Tribù nv
Oude Heidestraat 72
3740 Bilzen
BELGIUM
www.tribu.com
[email protected]
Put the tabletop on top of the assembly and x with 4 x small washer and 4 x screw.
Use an Allen key and apply normal force. DON’T USE A POWERTOOL.
You can use the adjustable feet to level the table.
5
6
Attention: Never move the table when it is assembled. In case the table has to be moved to a
new location, always dismantle the top from the base to avoid damages.

CONTENT ASSEMBLY INSTRUCTIONS
1 x
Tabletop round/square
1 x
Base
1 x
Nut
4 x
M6x12
1 x
Top mount
1 x
Leg
2 x
Large washer
1 x
Threaded rod
4x
Washer
T-Table is available in 3 table heights. Make sure you combine the correct
threaded rod with the correct leg. The threaded rod is a little bit longer than the
leg.These components are packed together.
Place the base in the designated location on a level surface and insert the
threaded rod. Make sure the welded nut is facing downwards. Use the large
washer. Make sure to tighten with a ring spanner.
Position the leg over the thread rod. Make sure it ts into the base.
The 4 pins on the bottom side of the leg t into 4 designated holes.
1
2
3
4Position the top mount on the leg and x with 1 x large washer and 1 x nut.
Use a socket spanner to tighten with maximal force.