Adastra BC3 User manual

BC-SERIES
Indoor Speakers
User Manual
BC3
75mm (3”), 60Wmax
White - pair
100.898
Black - pair
100.899
BC4
100mm (4”), 70Wmax
White - pair
100.901
Black - pair
100.902
BC5
130mm (5.25”), 90Wmax
White - pair
100.904
Black - pair
100.905
BC6
165mm (6.5”), 120Wmax
White - pair
100.907
Black - pair
100.908
BC8
200mm (8”), 180Wmax
White - pair
100.910
Black - pair
100.911
Introduction
Thank you for choosing the BC-series indoor speakers. These speakers have been designed to offer high
quality sound for low impedance installations. Please read and follow the instructions in this manual to
achieve the best results and avoid damage through misuse.
Installation
The BC-series speakers are each supplied with a wall-mounting bracket which
allows 90° lateral adjustment. When fixing to a wall or ceiling, use the bracket to
mark out the fixing points and use appropriate fixings for the substrate that the
speaker will be attached to, ensuring that the fixing is strong enough to bear the weight.
Once the bracket is fitted, support the speaker in position and attach top and bottom using the supplied
screw caps and adjust to the required angle. Further mounting points are available at the rear of the
speaker, should it be preferred to use different mounting methods (e.g. 129.130 –129.124UK)

BC-series User Manual
Connection
BC-series speakers are connected via 2 spring terminals at the rear of the
enclosure. With the amplifier switched off, strip the speaker wire ends and
connect the “+” wire to the red terminal and connect the “-” wire to the
black terminal.
When connecting to the amplifier, refer to the amplifier manufacturer’s
manual to ensure that total speaker impedance (Ω) on any channel is not
less than that recommended for the amplifier. It is also imperative that the amplifier does not deliver more
power than can be handled by the BC speaker. Refer to the amplifier manual and specifications below to
calculate this. Normally, it is recommended that the amplifier is capable of the RMS power rating of the
speaker but cannot ever exceed the Max power rating.
Specifications
Model
BC3
BC4
BC5
BC6
BC8
Woofer
75mmØ (3“)
100mmØ (4”)
130mmØ (5.25”)
165mmØ (6.5”)
165mmØ (6.5”)
Tweeter
25mmØ (1“)
25mmØ (1”)
25mmØ (1”)
25mmØ (1”)
25mmØ (1”)
Freq response
120Hz - 20kHz
110Hz - 20kHz
100Hz - 20kHz
80Hz - 20kHz
50Hz - 20kHz
Power max : 8Ω
60W
70W
90W
120W
180W
Power rms : 8Ω
30W
35W
45W
60W
90W
Dimensions (mm)
106 x 153 x 106
150 x 195 x 150
180 x 240 x 180
220 x 280 x 220
280 x 375 x 260
Weight
840g
1.25kg
2.00kg
2.50kg
5.26kg
SPL @ 1W/1m
88dB
88dB
88dB
89dB
89dB
Caution
The BC-series speakers are intended for indoor use. Avoid moist or dusty environments.
Avoid excess heat and exposure to direct sunlight.
Take care not to overload speakers. HF drivers are especially prone to damage through overload.

BC-series User Manual

BCV-series User Manual
Errors and omissions excepted.
Copyright© 2015. AVSL Group Ltd.