ADEEPT B08LGR7RBF User manual

Assembly instructions
Adeept Flash Christmas Tree DIY Kit
Colorful 3D Xmas Christmas Tree Led
DIY Kits
ASIN: B08LGR7RBF
Product: https://www.amazon.com/dp/B08LGR7RBF

1．Work Schematic:

NOTE: Users can complete the installation by PCB silk screen
and component listing!

2. Component Description
1>. 3pcs 1K Metal Film Resistor
2>. 1pcs 2.2K Metal Film Resistor

3>. 3pcs 10K Metal Film Resistor
4>. 3pcs 47uF 16V Electrolytic Capacitor
5>. 19pcs 3mm White LED
6>. 3pcs S9014 Transistor TO-92
7>. 1pcs PCB CTR-30A
8>. 3pcs 1K Metal Film Resistor
9>. 3pcs 10K Metal Film Resistor
10>. 3pcs 47uF 16V Electrolytic Capacitor
11>. 18pcs 3mm White LED
12>. 3pcs S9014 Transistor TO-92
13>. 1pcs PCB CTR-30B
14>. 1pcs Self-Locking Switch
15>. 1pcs 3.5mm DC Power Socket
16>. 1pcs AA*3 Battery Box
17>. 1pcs USB to DC 3.5mm Cable
18>. 2pcs Screw M2*8mm
19>. 2pcs Nut M2
20>. 1pcs PCB CTR-30C

3.Installation Steps:
(1) -- Install Board CTR-30A

Step 1: Install 3pcs 1K Metal Film Resistor on R2,R4,R6

Step 2: Install 3pcs 10K Metal Film Resistor on R1,R3,R5
Step 3: Install 1pcs 2.2K Metal Film Resistor on R7

Step 4: Install 18pcs LED.
Tips:
A. Note the direction of the LED
B. Control distance between PCB edge and LED
head(Two ways).

1). User can bend the LED pin at first after determining
the distance and then insert LED to PCB through hole;
2). Insert LED to PCB through hole at first.Then
determine the distance.Bend the LED pin at last.

Step 5: Install 3pcs 47uF 16V Electrolytic Capacitor

Step 6: Install 3pcs TO-92 S9014 Transistor
Tips: It is better to bend S9014's pin so that 2pcs PCB
CTR-30A and
CTR-30B can better splicing.

Great!! CTR-30A has been installed completed.

(2) -- Install Board CTR-30B

Step 7: Install 3pcs 1K Metal Film Resistor on R2,R4,R6

Step 8: Install 3pcs 10K Metal Film Resistor on R1,R3,R5

Step 9: Install 18pcs LED

Step 10: Install 3pcs 47uF 16V Electrolytic Capacitor
Step 11: Install 3pcs TO-92 S9014 Transistor

Step 12: Connect 5V to CTR-30A and
CTR-30B.Preliminary welding
success if LEDs are blinking automatically