AdirPro LD-8 User manual

LD-8 RECEIVER
OPERATING MANUAL
Item #790-01

S p e c i fi c a t i o ns
Weight
7.1 oz
Dimensions
2.75" x 5.5" x 1"
Housing
Plastic rubber with trimming
Accuracy
Fine: ±1 mm; Coarse: ±2.5 mm
Power Source
(1) 9V battery
Battery Life
40 hours (approx)
Low Battery Indicator
Yes
Operating Temperature
14°F-122°F (-10°C~50°)
Volume Settings
Loud & low
Display
Liquid crystal
Automatic Shut-Off
Approx 10 minutes
Warranty
Limited lifetime
Included
Laser detector, clamp, (1) 9V battery

LCD Display
Coarse grade sensitivity
Fine grade sensitivity
Above reference h
i g h frequency b e ep )
shou l d move d o w n
Reference ( l ong b e ep )
Below
reference lo w frequency b e ep )
shou l d move u p
Volume Icon
Battery Level Indicator

Control P a nel
Bubble level – An extra measure of leveling accuracy
LCD - Front display shows the elevation, grade sensitivity, audio, and battery status
Laser Receptor - Hold the laser receptor. Face the rotary
laser to measure the accuracy
Mark - The marking notch is 4.5 mm (1.75”.) from the top of the receiver
Accuracy Mode –Switch between ultra fine and very coarse accuracy
Volume - Press this, volume will switch between high noise and low noise
Power ON/OFF - multi-functional button that is used to turn on/off
Magnetic strip – Allow you to affix receiver on any metalsurface

Back Panel
LCD –Back display shows the elevation, grade sensitivity, audio,
and battery status
¼” Thread mounting nut –The clamp securely attaches here
Battery compartment –Holds the battery securely in place

1. Open the battery door using a coin or your thumbnail.
2.
Install/Remove the 9V battery noting the positive (+) and negative (–) diagram inside the housing.
3. Push down on the battery door until it
“clicks” into position.

General Purpose Clamp
The general purpose clamp allows the receiver to be attached to a grade rod or wooden pole.
Features and Functions
Bubble level –An extra measure of
leveling accuracy
Clamp –Ridged edges give extra
friction to secure the clamp to a
grade rod or pole
Width adjuster –Non-expanding
bolt adjustment system that adjust
with a screwing motion
Mounting thread –¼” thread screw
to secure receiver to the clamp

I r v i n gto n NJ 07111 | [email protected] | www .adirpro.com