AEO E-power 5A 1S User manual

无刷马达电子调速器（ ESC）说明书
产品介绍
产品功能简要说明
电调使用调试说明
感谢您购买本产品！无刷动力系统功率强大，错误的使用可能造成人身
伤害和设备损坏。为此我们强烈建议您在使用设备前仔细阅读本说明书，并
严格遵守规定的操作程序。我们不承担因使用本产品或擅自对产品进行改造
所引起的任何责任，包括但不限于对附带损失或间接损失的赔偿责任。
1. 所有器件均为原装正品，确保电调具有一流品质和极高的可靠性。
2. 具有强大的耐流能力。
3. 可设定油门行程，兼容各种遥控器。具备平滑、细腻的调速手感、一流的调
速线性。
4. 最高转速可以达210000 RPM（2 极马达）、70000 RPM（6 极马达）、
35000 RPM（12 极马达）。
1. 电池类型：Lipo（锂电池）。
2. 电池低压保护模式：电压到达低压保护时限制油门最大开度只到40%。
3. 进角：分低、中、高三档。
一般情况下，低进角可以适应较多的马达。但是因为马达结构差异很大，请试用各个进角以获得满意的驱动
效果。改变进角后，建议先在地面进行测试，然后再飞行。
首次使用您的无刷电子调速器
特别强调！为了让电调适应您的遥控器油门行程，在首次使用本电调或更换其他遥控器使用时，均应重新设定油门行程。
油门行程设定
正常开机使用过程
使用遥控器编程设定说明
开启遥控器
将油门开到
最高点
将电调接上电池，
等待2秒
电调发出“哔-哔”
油门最高确认音
将油门推至最低，
等待1秒
N声短鸣音表示
保护锂电节数
提示音“♫123”
油门最低点确认音
系统准备就绪
可以起飞
开启遥控器
将油门开到
最低 点
电调接电发出N
声短鸣音，表示
保护锂电池节数
提示音“♫123”
表示上电正常
系统准备就绪
推油门可以随
时起飞
开启遥控器
将油门开到
最高点
将电调接上电池，
等待2秒
电调发出“哔-哔”
油门最高确认音
再等待4秒左右，
鸣提示音
“♫12345”表示
进入功能设置
循环发出1-7声
提示音，对应
1-7功能设定
听到某功能提示
音后拉低油门发
声“♫45”表示
选择该功能
选择完成推高油
门继续功能设置，
把油门拉最低退出设置
功能1：自动检测锂电个数，并根据检测到的锂电个数设定保护电压
（每节锂电保护电压2.8V）
功能2：保护2节锂电
功能3：保护3节锂电
功能4：低进角
功能5：中进角
功能6：高进角
功能7：恢复出厂默认设置
出厂默认设置：自动检测锂电个数、低进角
注意：本说明不适合E-Power 5A（1S/2S）

Instructions for Brushless Motor ESC
Introduction
Function
Setting Instruction
•Thank you for purchasing this product. It is strongly recommended that you read
this manual carefully before using the device and strictly comply with the specified
operating procedures. We are not responsible for any liability arising from the use
of this product.
1.All devices are original and genuine, ensuring that the ESC is of the highest quality and high
reliability.
2. It can withstand a higher current.
3. It can set the throttle stroke, compatible with a variety of remote control .With smooth and
delicate feel of speed control,first-class linear speed regulation.
4. The maximum speed can be reached 210,000 RPM (2-pole motor), 70,000 RPM (6-pole motor)
and 35,000 RPM (12-pole motor).
1. The type of battery: Lithium battery / NI-MH battery
2. Battery low voltage protection mode: limit the throttle to only 40% when the voltage reaches low voltage protection.
3. Advance angle: divided into low, medium and high.
In general, the low advance Angle can accommodate more motors. However, as the motor structure is quite different, please try each advance
Angle to get a satisfactory driving effect. In order to improve the speed, the advance Angle can be set as the high advance Angle. After
changing the approach Angle, it is recommended to test on the ground before flying.
Using your brushless ESC for the first time
Please pay attention! In order to adapt the ESC to your remote control throttle stroke, the throttle stroke should be resetting for the first time when using this ESC
or changing other remote controls, so as to get the best linear throttle.
Setting instructions of throttle stroke
Instruction of Normal Boot
Programming instructions for using the remote control
Function 1: Automatically detect the number of lithium batteries,
and set the protection voltage according to the number of detected
lithium batteries(each lithium battery protection voltage 2.8V)
Function 2: Protect 2 lithium batteries
Function 3: Protect 3 lithium batteries
Function 4: Low advance angle
Function 5: Medium advance angle
Function 6: High advance angle
Function 7: Restore factory defaults
Factory default setting: automatic detection of the number of
lithium batteries, low advance angle.
Turn on the
remote
control,then adjust
the throttle to the
highest point.
Turn on the remote
control,then adjust
the throttle to the
lowest point.
Turn on the remote
control,then adjust
the throttle to the
highest point.
Connect the ESC
to the battery and
wait for 2 seconds.
The ESC issued the
"Bi-Bi-" indicate the
throttle to be the
highest.
Wait for about 4
seconds, the beep
sound "♫12345"
means to enter the
function settings.
Loops 1-7 sounds,
corresponding to 1-7
function settings.
After hearing a certain
function sound, pull
down the throttle and
sound "♫45" to select
this function.
After completing the selection,
push up the throttle to
continue the function setting,
and drop down the throttle to
exit the setting.
The lowest voice
"♫123" from ESC
indicates the
throttle to be the
lowest.
The system is
ready to take off.
Push the throttle to
take off at any time.
Connect the ESC to
the battery and
wait for 2 seconds.
The ESC is powered
by a short beep to
indicate the number
of lithium battery
segments.
The prompt "♫123"
indicates that the
normal system is
ready for power-on.
The highest voice
"bi-bi" from ESC
indicates the throttle
to be the highest.
Push the throttle to
the lowest and wait
for 1 second.
The sound of short
beep indicates the
number of lithium
battery protection.
Note: This manual is not suitable for E-power 5A (1S/2S)