Agaphatek MED-8150 User manual

Turning the Computer On and Off
To turn on the computer
1 Connect the AC adapter . (Refer to the Gettin g Started Guide .)
2 Adjust the stand at the back of the computer to a comfortable angle.
3 Slide the Power Switch to the right, hold it for more than 1 seconds and then release it.
The computer is turned on.
To turn off the computer
1 Click the start button ( ) on the taskbar.
2 Click Turn Off Computer .
3 Click Turn off
When the system cannot be shut down due to a system error, turn it off by sliding and holding
the Power Switch for more than 4 seconds.After that, when turning it on by sliding the Power
Switch, the disk checking program may launch.
F or m ore i n f or m a t i on re g a r di n g s e tt i n g u p a n d u s i n g MED-8150 / FTP-8681 , pl e a s e v i s i t our w e b s i t e a t
www . agapha.com
Q u i c k S t a r t G u i d e
MED-8150/FTP-8681
15” FanlessTouchScreenPC
Caution
Always provide proper grounding when performing repairs. Without
propergrounding, an electrostatic discharge can damage the tablet
PC and its components.

W ha t ’ s i n t he B o x
Y our Tablet P C s hou ld c o m e s e c ure l y p ac k a g e d i n i t s s h ippi n g ca r t on a l on g wi t h t he i t e m s li s t e d b e l o w .
P l e a s e c on t ac t your d e a l er imm e di a t e l y if you fi n d t h a t a ny t h i n g i s mi ss i n g or d a m a g e d .
1. P o w er C or d a n d A C A d a p t er(19V IN)
2. A ppli ca bl e O p er a t i n g S y s t e m Q u i c k S t a r t G u id e
3. U t ili t i e s / Dr i ver s CD
1. USB Port 7. Earphone out
2. Handset Port 8. RESET Switch
3. CRT Port 9. POWER Switch
4. 19V DC IN Power Port 10. RJ-45 LAN Port
5. RS-232 Port 11. LCD Back-Light Adjust Resistor
6. Mic IN
Stylus Pen(Touch Screen)
A Stylus Pen is used instead of mouse and provides the same function
Before You Start!
It is recommended to connect and use a USB keyboard and mouse when using the computer for
a long time.
Taking the Stylus Pen Out
Pull the Stylus Pen upwards.
Stylus Pen Functions
Mouse Stylus Pen Function
Single-click Single-tap Single-tap with the pen to select an item.
Double-click Double-tap Double-tap with the pen to run an item.
Right-click Press and Hold
Press and hold for more than 3 seconds with the
pen to display the pop-up menu.
Drag Drag Press an item and drag it with the pen to move
the item.
Calibrating the Stylus Pen
When using the Stylus Pen for the first time or the pointing position of the Stylus Pen is incorrect,
you can correct the pointing position using the TouchKit program.
1 Select Start > All Progra ms > Touchkit > Configure Utility .
2 In the Tools tab, press the 4 Points Calibration .
3 Press and hold the X-symbol displayed on the screen until
it stops blinking. The X-symbol
appears repeatedly according to the selected number of points.