Air Structures International IGOAL User manual

Step 1
Roll IGOAL out of bag
onto level surface.
From
Air Structures International
Step by step
instructions to set
up your IGOAL
The crossbar will be straight and aid your
enjoyment of your game on a level surface.
This is a portable goal, ALWAYS take the
IGOAL where it is to be used.
The pump provided will only allow the IGOAL to
inflate to required pressure.
You do not need trainers or sports footwear
for this - high heels work ok!
On larger sizes the rear cantilever needs to be
secured to stop IGOAL tipping forward.
If ground is hard or stony it may be better to use
the sandbags.
Long slow pumps are more effective than trying
to go fast.
Make sure pump is not still attached to valve when
popping up IGOAL into position.
Step 2
Make sure net is not
caught on hose or
connectors.
Tip Tip
Tip Tip
Tip Tip
Tip Tip
This product is covered by a ONE YEAR GUARANTEE against
manufacturing defects – please refer to website for full details
www.airstructuresinternational.com
Step 3
Using the pump provided
(and only this pump) attach
to valve which is situated at
the side of IGOAL (rear of
cantilever on larger sizes)
making sure that the valve is
turned fully anti-clockwise.
Step 5
Inflate for approx. 20-30
pumps (under normal
circumstances) and screw
the valve cap back on tight
after inflation.
Step 7
Ensure that the IGOAL
is secured at all times by
means of the appropriate
supplied anchor system -
details below.
Step 4
Attach the other end of
the pump hose to the
INFLATE position on the
pump handle. Put feet on
the foot plates on either
side of the pump for
stability.
Step 6
Pop IGOAL up into
upright position. On
larger sizes it may be
necessary for 2 people to
carry out stage 6.
Step 8
If fixing on grass - please use
the ground pegs provided -
attach pegs provided at front
and back of both side returns.
On larger sizes with cantilever
- place 2 pegs overlapped
over each black cantilever.

Place sandbags with ties on outside of net. If IGOAL is in position for long periods or in
hot weather it be necessary to check pressure
periodically.
Note point 13 - do not fold the IGOAL - arrange
as the IGOAL falls to floor shuffling along roll-out
section - this will help when next using the IGOAL.
Following these instructions will greatly help your
future enjoyment of your IGOAL.
Don’t worry - you can push and shove the IGOAL!
The IGOAL will fall the way it needs to be packed. When all air has been removed from IGOAL you
cant pump anymore - stop.
Step 10
Once in position add more
air using pump provided to
pressure required.
Step 11
After use make sure the area
is clear of all obstacles and
people before deflation.
Step 12
To deflate the IGOAL -
push the valve in and twist
fully clockwise - the IGOAL
will fall to the ground.
Step 13
Remove all pegs or
sandbags after deflation.
Step 14
To aid packing, remove hose
from pump and re-attach to
the DEFLATE position on the
pump handle, then re-attach
the other end of the pump
hose to the IGOAL with valve
turned fully clockwise and
pump several times to remove
any residual air as above.
Step 15
Place IGOAL on the roll-out
section of the bag with valve
turned fully to the left and
with the valve cap replaced.
Step 17
There is no ongoing
maintenance subject to
product not being misused
or handled carelessly.
Important
Looking after your IGOAL by following these simple instructions
will help to maintain the quality of the IGOAL.
Warning
> Never drag the inflated/deflated IGOAL on hard ground as it
will damage the goal.
> Make sure you suck out the residual air with pump before
rolling goal back into the bag.
> Do not expose to chemicals, such as thinner, gasoline
and acetone.
> Do not use the IGOAL when it is frozen.
> Do not leave the IGOAL outdoors permanently
Tip Tip
Tip
Tip
Tip
Tip Tip
Step 9
If fixing on other surfaces i.e.
Astroturf, concrete or inside -
please use bags provided which
should be fully filled with soft
sand to ensure even distribution of
weight - place the sandbags over
both side returns. On larger sizes
also place one sandbag over each
black cantilever as above.
Step 16
Carefully roll the IGOAL
back into bag, put pump on
top of the roll-out section,
close top zippers first,
then side zippers after any
protruding parts are back
inside the bag.