AirArtDeco FT-15RT1 User manual

6” Table Fan (USB)
INSTRUCTION MANUAL
Model: FT-15RT1
READ AND SAVE THIS INSTRUCTION MANUAL

1
INSTRUCTIONS
Read the instructions and keep them safe. If you pass the appliance
on, pass on the instructions too. Remove all packaging, but keep it till
you know the appliance works.
IMPORTANT SAFEGUARDS
Follow basic safety precautions, including:
1. Read all instructions.
2. This fan should be used by, or under the direct
supervision of, a responsible adult.
3. Do not put the appliance in liquid; do not use it in
the bathroom, near water, or outside.
4. Unplug the fan when it is not in use, and before
moving or cleaning it.
5. Do not put fingers, pencils or any other object
through the front/rear guard.
6. Supervise children around the fan when it is
plugged in. This type of fan fascinates children but
they should not be allowed to play with it.
7. Select a suitable location for the fan. Always
choose a safe location in accordance to the safety
recommendations outlined.
8. Put the fan on a stable surface. Do not place it on a
soft or unstable surface like a bed or upholstery.
9. Place the power cord in the way that it does not
hang down, for someone to trip over or get
entangled in.
10. Do not place the fan near an open window, to avoid
the possibility that rain could cause an electrical
fault.

2
11. Do not hang or mount the fan on a wall or ceiling.
12. Keep the fan and power cord away from fires and
heaters.
13. Do not use the fan for any purpose other than
described in the instructions.
14. Do not use the appliance if it is damaged or not
working correctly.
15. If the power cord is damaged, it should be changed
by the manufacturer, its service agent or another
qualified person –to avoid danger.
16. This appliance can be used by children aged from 8
years and above and persons with reduced physical,
sensory or mental capabilities or lack of experience
and knowledge if they have been given supervision
or instruction concerning use of the appliance in a
safe way and understand the hazards involved.
Children shall not play with the appliance. Cleaning
and user maintenance shall not be made by children
without supervision.
17. The fan must only be supplied at safety extra low
voltage corresponding to the marking on the
appliance.
18 Warning! It's strictly forbidden to remove the protective guards
during maintenance or cleaning.
Never use the fan without the guards in place.

3
OPERATING INSTRUCTIONS
1. Before connecting the appliance, check if the voltage indicated on
the rating plate correspond to electric mains voltage in your home.
Plug the power cord into a suitable socket.
2. Read and follow all the instructions in this manual even if you feel
you are familiar with the products, and find a place to keep it
handy for future reference.
WARNING: Be sure to shut off electric supply at main switch or
circuit breaker before installation. The important safeguards and
instruction appearing in this manual are not meant to cover all
possible conditions and situation that may occur. It must be
understood that common sense, caution and care are factors which
cannot be built into any product; these factors must be supplied by
the person(s) caring for and operating the unit. No responsibility will
be accepted for any damage which may occur during transport or by
improper installation or voltage fluctuation or if any portion of the
product has been altered or modified.
NOTE: The rating of this product (as marked on the product
identification plate) is based on specific loading tests. Use of other
recommended attachments may draw significantly less power.

4
POWER SOURCE
1. USB powered: Plug the USB power cord into a PC
2.Main power outlet: insert USB power cord is greater than 2
A/DC5V adapter, then insert a suitable mains socket.
ON/OFF SWITCH
Step 1: Set fan on a dry, level surface.
Step 2: Please make sure the Speed Selector Switch is
in the Off (0) position. Plug USB cord into any A/C adaptor and then
plug into a suitable main power socket, or Plug the USB power cord
into a PC
Step 3: The speed selector switch is located on the back of the rear
grill. Press the selector switch to turn the fan to the desired setting,
0 (Off), I (Lo) , II (Hi).
TILT ADJUSTMENT INSTRUCTIONS
VERTICAL ANGLE ADJUSTMENT –To adjust the angle of the fan
head, simply move the fan head to the desired angle. Lastly, be sure
to firmly tighten the Tilt Adjustment Knob to keep the fan head in
place.
CLEANING
It is forbidden to disassemble the grids (guard) when cleaning.
Always unplug the fan before cleaning.
•Do not allow water to drip on or enter into fan housing.
•Be sure to use a soft cloth moistened with a mild soap solution.
•Do not use any of the following as a cleaner: Gasoline, thinner, or
benzene.
Clean the fan grill, housing and base with a soft, damp cloth. DO NOT
ATTEMPT TO REMOVE THE FAN BLADE.
Please use caution around the motor housing area. Do not allow the
motor or other electrical components to be exposed to water.
Net weight: 1.03kg