airquee Catch it Quick Game Operating instructions

Page 1of 6
IMPORTANT
AS THE OWNER/OPERATOR IT IS YOUR RESPONSIBILITY TO WRITE AND CARRY
OUT YOUR OWN RISK ASSESSMENTS BEFORE ATTEMPTING TO USE THIS
PRODUCT.
** The following instructions are on addition to the main operation manual
supplied which should be read before the installation and setup of this unit**
** Please also see the reference regarding electrical safety on page 8 of this
document.
Installation instructions for ‘Catch it Quick Game’
1 x Arch
1 x control box
6 x sticks
6 x diamonds
1 x
magnetic
tube

Page 2of 6
1. The first step is unpacking the unit, you should have received the following
items:
The sealed arch
Sticks (6 pieces)
Diamonds (6 pieces)
Control box
Magnetic tube
Electric cable
Anchors (4 pieces)
Hand held fan
2. Inflate the unit with the hand held fan and you will have the arch. Stabilize the
unit with the four anchors.
3.
4. The magnetic tube will be attached to the top part of the arch with the help of
the metal rings attached to the two carabiners.

Page 3of 6
5. The magnetic tube is connected to the control box with a cable, so you need to
be careful only to place it in a way that will not tangle anyone around the game.
6. The cable need to be fixed with Velcro onto the arch as seen in the pictures
below:
7. Next step is to assembly the control box which has three parts as seen in the
images below:
Part A –the control box

Page 4of 6
ASSEMBLY OF THE CONTROL SYSTEM:
- Remove the two screws from the part B and after this place part B into part C
as seen in the picture below:
- Insert the control box into into the top part of part B as seen bellow, do not forget
to screw and tighten the two screws into part B : -see images:

Page 5of 6
- Do not forget to connect the magnetic tube to the control box –see images:
The control box is the only thing that needs to be plugged in.
The red light turns on only when the control box is plugged in and it is under
power.

Page 6of 6
The ON/ OFF turn button activates the game. If you turn it toward the “ON” mark
it means that the magnets are activated, while if you turn it to “OFF” it means that
the control box is turned off.
The 6 red buttons in form of a V shape, control the magnets. When you push the
button the corresponding stick will fall down. If you want the magnetic stick to be
on its place again you need to turn the button, and the button will pop up and the
magnet can be attached again to the magnetic place. When all of the stick fell
off, the solution is the same, meaning that you will have to turn all the six red
buttons and they will pop in place, and the magnets can be put back.
There is a grey switch at the bottom of the control box, from where you can open
the box and this way you gain access to the electrical parts. (No unauthorized
personnel should use this).
IMPORTANT: When the unit is turned off be sure not to only switch off but also
unplug it.
CAUTION:
All sealed inflatables use a hand held fan. For safety reasons it is vital to use the
correct fan specified for the inflatable. If the inflatable starts to show signs of loss of
air pressure it will start to sag noticeably, play should be suspended immediately and
the cause of the pressure loss investigated before play is resumed.
A common cause of pressure loss is physical damaged to the inflatable. However do
check the bung is closed properly.
Hazards relating to electrical equipment!!
The use of portable electrical equipment involves the potential risk of electric shock,
burns or fire. A major cause of accidents is failure to maintain equipment. The risk
can be managed effectively if sensible and appropriate rules for use and
maintenance are applied!
The control box and the wiring used within the game are not water proof or water
resistant. Therefore we do not recommend operating the unit in the rain.
Using electrical equipment in wet or damp conditions can be dangerous.
If you suspect water has entered any of the electrical components they should not be
used until completely dryand tested. We recommend taking professional advice where
necessary.
All cables and electrical equipment must be tested in accordance with the
regulations of your country.
In accordance with HSE guidelines all 240v equipment should be protected with an
RCD (Residual Current Device) having a maximum trip current of 30 mA.
RCD’s are available from Airquee or your electrical store.