airquee WORLD'S BIGGEST BOUNCY CASTLE User manual

Page 1of 5
WORLD’S BIGGEST BOUNCY CASTLE
** The following instructions are on addition to the main operation manual supplied
which should be read before the installation and setup of this unit**
IMPORTANT
AS THE OWNER/OPERATOR IT IS YOUR RESPONSIBILITY TO WRITE AND CARRY OUT
YOUR OWN RISK ASSESSMENTS BEFORE ATTEMPTING TO USE THIS PRODUCT.
Site survey:
1. Carry out a survey of the area where the unit will be located, and check for any
overhead/underground cables or other services. It is important that this is carried out
to avoid ground anchors penetrating underground services, and the unit coming into
contact with overhead cables when inflated.
2. You should provide an adequate power supply to the fans, this should adhere to
your local power regulations. Look at the information label on the blower to see how
much power it uses.
3. Important: We recommend to have a generator on site in case of power failure due
to the high number of users allowed onto the unit. Or at least one fan to be powered
from a generator on each part of the unit in case of power failure.
4. Due to the size of this inflatable continuous checks should be carried out to ensure
the safety of users at all times.

Page 2of 5
Additional guidance:
1. The number and height of the users allowed is stated on the front of the castle and
this must be strictly adhered to.
2. NO one with any pre-existing injuries or health concerns is allowed on the bouncer.
3. We recommend at least 4 supervisors to be inside of the unit and at least 4
supervisors to be around the inflatable positioned at the entrances and emergency
exits’ of the unit. Due to the size of the inflatable all supervisors must be fully aware of
the evacuation procedures and emergency plans.
4. Separate users into groups of approximately the same height, this is avoid the more
boisterous users coming into contact with the smaller users.
5. It is imperative for the unit to be positioned in a place where there is enough free
space above it in order to avoid contact with any cables, branches etc.
6. Make sure that the unit is positioned in a place where there is enough space around
the entrances and the exit doors in order to allow users to enter and exit in a safely
manner also in case of evacuation.
Setting up:
Your unit comes in four parts which will need to be connected before inflation.
The outer edges of the unit have big anchors (fig.1) and the inner part of the unit has
small anchors (fig.2).

Page 3of 5
fig.1 fig.2
You can start connecting the unit by first attaching only two parts by connecting their
small anchors on to each other using the carabiners provided. Then you can continue
with other parts until you connect all four parts –see images:

Page 4of 5
After all four parts are connected with the carabiners, please continue connecting the
unit with the sandwich Velcro.
After the bed is velcroed the walls also need to be connected with Velcro before
inflation –see image:
Wall of the unit

Page 5of 5
After connecting all four parts together please connect the fans to the unit as described
in the Operation Manual provided and start inflation.
Anchor the inflatable temporarily to avoid movement during inflation. Once inflated
reposition and anchor fully as per the Land Operation Manual guidelines.
There are two entrances (fig.1) and two emergency exist (fig.2) on the unit –see
pictures:
fig.1 fig.2
At the two entrance doors there is a step cover which needs to be velcroed in place –
see images:
Recommended daily checks:
- Please see page 14 on the Operation Manual
- Please also check the carabiners connections daily –or if the unit is in use for
several hours a day please take some short breaks for safety checks