
8
Assembly and Installation Instructions
Tools (Safety Enclosure)
Installation of the safety enclosure requires a 13mm hex wrench (included) or a deep socket with a ratchet or cordless
drill, and a 5mm Allen wrench (included). An 8 foot A-Frame ladder will be useful for some steps (use care and follow
procedures for use). Safety glasses and gloves are also recommended for safety.
Parts List (Safety Enclosure)
Your 10ft VariableBounce Trampoline System is shipped with the parts shown below. The safety enclosure parts ship in
a separate box, which has a smaller box inside of it. If any parts are missing, immediately call AlleyOOP Sports Custom-
er Service at 408-213-2551.
Note: Do NOT discard the foam tubing (Reference #12 and #13); it is needed to make the pole assemblies. It is not
just packing material. Do NOT remove any caps from the ends of any of the support poles.
Nylock nut (Ref. #16d)
Acorn nut (Ref. #16e)
Reference # Part # Description Quantity
10 POL-A-11216A Lower support pole, with snap-button 6
11 POL-P-11332A Upper support pole, notch at one end 6
12 FOA-P-10078A Long foam tubing (1 tube packed over 1 pole) 6
13 FOA-P-10103A Short foam tubing (2 tubes packed over 1 pole) 6
14 SLE-P-11398A Pole sleeve, green vinyl 6
15 CAP-P-10075A Ball end cap 6
16a BOL-P-10081A M8 bolt, Allen head 12
16b SPA-P-10083A Pole spacer, black 12
16c WAS-P-10082A Washer 24
16d NUT-P-10084A M8 Nylock nut 12
16e NUT-P-10622A M8 acorn nut, capped end 12
17 TOO-P-10158A Wrench, 13mm hex 1
18 TOO-P-10159A Wrench, 5mm Allen 1
19 NET-P-21203-00 Heavy-duty net 1
20 STR-P-11150A 30” strap with buckle 8
Tools (Trampoline)
No tools are required for installation of the trampoline. However, safety glasses and gloves are recommended for safety.
Parts List (Trampoline)
Your 10ft VariableBounce Trampoline System is shipped with the parts shown below. The trampoline parts ship in 2
separate boxes which may arrive on different days. If any parts are missing, immediately call AlleyOOP Sports Custom-
er Service at 408-213-2551.
Reference # Part # Description Quantity
1LEG-A-11229-01 Horizontal leg piece 3
2LEG-P-11228-01 Vertical leg piece 6
3RAI-P-11227A Rail piece with 2 leg sockets, 12 spring notches 3
4RAI-P-11226A Rail piece with no leg sockets, 12 spring notches 3
5MAT-S-11287A Mat, 72 V-rings 1
6SPR-P-10059A Spring, 8.5 inches 72
7a PAD-A-11237A Frame pad section 6
7b PAD-P-11311A Pad connector, with Velcro (connects frame pad sections) 12