Alpaca IF-2018F User manual

- 0 -
IF-2018F
ELECTRIC FIREPLACE
User Manual
SAVE THIS MANUAL
You will need this manual for safety instructions, operation procedures, and warranty. Put it and the
original invoice in a safe, dry place for future reference.

- 1 -
IMPORTANT SAFETY INSTRUCTIONS:
When using electrical appliances, basic precautions should always be followed to reduce the risk of
fire, electric shock and injury to persons including the following:
1. Read all instructions before using this appliance.
2. This appliance is hot when in use. To avoid burns, don’t let bare skin touch hot surfaces. The grill at
the bottom of this heater in particular will become hot when the heater is active. Keep combustible
materials such as furniture, pillows, bedding, papers, clothes and curtains etc. At least 3
feet(0.9m)away from the front of the appliance. Keep all items away from the sides and back of the
appliance and take special care not to block the air intake or exhaust vents. Use handles when
moving this heater.
3. Extreme caution is necessary when the appliance is used by or near children or invalids and
whenever the heater is left operating and unattended.
4. Do not operate the appliance if the power cord or plug has been damaged or the heater has been
damaged or malfunctioned in any way. Take the appliance to authorized service facility for
examination, electrical or mechanical adjustment or repair.
5. Do not use outdoors.
6. Do not use the appliance in bathrooms, laundry areas and similar indoor locations, Never locate the
appliance where it may fall into a bathtub or other water container.
7. Do not run the power cord under carpeting. Do not cover cord with throw rugs, runners, or similar
coverings. Do not route cord under furniture or appliances. Take care to position the cord away
from high traffic areas and such that it can not be tripped over.
8. To disconnect the appliance, turn all controls “OFF”, then remove the plug from the outlet.
9. This appliance has a polarized plug(one blade is wider than the other). This plug will fit in a fully in a
outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does fit,
contact a qualified electrician to install the proper outlet. Do not change the plug in any way
10. Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this may cause
an electric shock or fire, or damage the appliance.
11. To prevent a possible fire, do not block air intakes or exhaust in any manner. Do not use on soft
surfaces like a bed, where openings may become blocked.
12. A heater has hot and arcing or sparking parts inside. Do not use in areas where gasoline, paint or
flammable liquids are used or stored.
13. Use this heater only as described in this manual. Any other use not recommended by the
manufacturer may cause fire, electric shock or injury to persons.
14. Always plug heaters directly into a wall outlet/receptacle. Never use with an extension cord or
relocatable power tap.
15. Do not attempt burn wood or other materials in this heater
16. When transporting or storing the heater, take care to keep both the unit and power cord/plug dry,
free from excessive vibration and away from heat sources.
17. This appliance comes equipped with an overheat protection safety device. Should the appliance
begin to overheat for any reason, it will automatically turn all heater functions of the appliance off.
The appliance will have to be reset prior to continuing use. To reset the overheat protection safety
device, turn all controls, plug the appliance back and turn on
TECHNICAL SPECIFICATIONS
Model#
IF-2018F
Rate Voltage
AC 120V, 60Hz
Rate Amps
11.67Amos
Rate Power(Total)
1400W
SAVE THESE INSTRUCTIONS FOR FUTURE USE
Warning: Any use of this appliance other than recommended by the manufacturer in
these users manual may cause fire, burns, electric shock and /or other serious injuries

- 2 -
ELECTRIC FIREPLACE INSTALLATION
Plugging in the heater
NOTE:
1. This heater is for use on 120 Volts.
2. A 15AMP circuit is required to operate this appliance. If the breaker trips when the appliance is
running, you may need to move the appliance to another location or unplug other appliances that are
on the same circuit
3. ADAPTERS ARE NOT ALLOWED CANADA
NOTE: A 15AMP,120 Volts circuit is required. Dedicated circuit is preferred but not essential in all cases,
a dedicated circuit will be required if, after installation, the circuit breaker trips or the fuse blows on a
regular basis when the heater is operating. Additional appliance on the same circuit may exceed the
current rating of the circuit break.
WARNING:
1. Ensure the power cord is not installed so that it is pinched or against a sharp edge and ensure that
the power cord is stored or secured to avoid tripping or snagging to reduce the risk of fire, electric
shock or injury to persons.
2. Construction and electrical outlet wiring must comply with local building codes and other applicable
regulations to reduce the risk of fire, electric shock and injury to persons.
3. Do not attempt to wire your own new outlets or circuits. To reduce the risk of fire, electric shock or
injury to persons, always use a licensed electrician.
BEFORE USING THIS APPLIANCE:
1. Please check the circuit break for this appliance on
2. The information regarding this appliance can be found on the rating plate located on the back of the
unit
PLUGGING IN THE HEATER:
1. Make sure the appliance main “I/O”is switch OFF(refer to operating instruction section)
2. Plug the unit into a no less 15Amp/120V outlet.

- 3 -
OPERATING INSTRUCTIONS
NOTE:
1. When you first turn the heater on, it may emit a slight but harmless odor. This odor results from
certain oils or greases being heated as the appliance is used for the first time. This odor is perfectly
safe and will stop shortly, it will not reoccur after the first operation of the appliance.
Control Panel
Power Switch is control power ON or Power off, Heating Switch is control Heater on or heater off
CLEANING
1. To remove dust from glass window, please use clean dry cloth.
2. To remove fingerprints or other marks from glass window, please use clean damp cloth. Do not spray
glass cleaner or other liquids directly onto the window.
3. Clean metal surfaces with a clean damp cloth making sure not to push dust or debris into any air
intake or exhaust vents.
4. Do not use abrasive cleaners or spray liquids on any part of the appliance.
TROUBLE SHOOTING
FREQUENTLY ASKED QUESTIONS(FAQS)
PROBLEM
POSSIBLE CAUSE
SOLUTION
Flame is dim or not present
1. “Flame wand” has come
loose from bracket
1. Remove screws holding
back panel in place and
remove back panel. Secure
end of “flame wand” back into
the support bracket.
No warm air is coming from
the heater
1.The overheat protection
device in the appliance has
been triggered
1. Turn all controls off, unplug
the appliance, allow to cool for
at least 10 minutes, plug back
in and restart.
The appliance turns off and
will not turn back on
1.The overheat protection
device in the appliance has
been triggered
2. House circuit breaker has
been tripped.
1. Turn all controls off, unplug
the appliance, allow to cool for
at least 10 minutes, plug back
in and restart.
2. Reset house circuit
breaker.
Warning:Turn off the appliance, unplug and let cool for at least 10 minutes before
attempting to service. Only a qualified professional should attempt to service or repair
the appliance
Power Switch
Heating Switch

- 4 -
WARRANTY
Thank you for purchasing this product. These products have been made to demanding high quality standards and
are guaranteed for domestic use against manufacturing faults for a period of 12 months from the date of purchase.
This warranty does not affect your statutory rights.
For service within the warranty period, please contact the store where the product was purchased. Product model
number and proof of purchase are required for any service request. We reserve the right to repair or replace the
defective product, as its discretion
Normal wear and tear, including accessory wear, it not covered under this warranty. The product is guaranteed for
12 months if used for normal trade purpose, and is valid for the original buyer only. Any warranty is deemed invalid if
the product has been overloaded or used improperly, or subject to neglect or attempted repairs other than by an
authorized agent. Heavy-duty,daily professional or hire usage are not guaranteed. We are not responsible for any
costs related to labour, injuries or any other loss incurred during the product installation, repair or replacement,
including any indirect or consequential damages
Due to continuous product improvement, we reserve the right to change the product specifications without prior
notice.