Heat-N-Glo SL-32S User manual

LOG INSTALLATION FOR SL-32, SL-32S AND SL-32GDV
1. Remove trim door and glass.
2. Unpack all the logs. There should be 5 logs total. See Figure 2.
CAUTION: LOGS ARE FRAGILE; BE CAREFUL WHEN HANDLING.
3. Alternately place a single layer of dime size and shape pieces of Golden Ember (GE-93) and Glowing Ember
(050-721) onto the top of the burner.
FIGURE 1
454-935-C 10/97

4. Place Log#1onburner. Theleft side ofthe log should
beagainst the pilot bracket,tab 1 and tab 2. The right
sideofthe logshouldbe againstthetab1 ontheburner.
See Figure 2. Once in place push down onto tab 2.
5. Place Log #2 onto the burner such that the front tip is
against tab 3. See Figure 3.
NOTE: Do not place any logs directly on the burner in
such a way as to cover any burner ports.
6. PlaceLog #3 onto the burnersuch that the leftedge is
21/4" from the firebox side. Thelog should beagainst
tabs 4 and 5. See Figure 4. Tilt the log slightly back.
FIGURE 2
FIGURE 3
FIGURE 4

7. Place Log #4 such that the narrow end is against the
back left corner of the firebox, bark side up. The log
should extend over the pilot and rest on logs #1. See
Figure 5.
8. Place Log #5 onto logset such that it extends from log
#1 to the refractory. The log should be located ap-
proximately at the intersection of logs #3 and #2. See
Figure 6.
9. Replace glass and trim door.
FIGURE 5
FIGURE 6