8www.alpenoptics.de
the M key and select the item Brightness (item
4) or Contrast (item 5) by briefly pressing the M
key. With a short press on the M key you select the
desired level. You will automatically be taken one
step back in the menu.
Info: We recommend that brightness and contrast
should not be too far apart. e.g. brightness 2 and
contrast 9.
8. Clear+ mode
This mode is preset at the factory. We recommend
using it this way. If you do not want the edges and
detail optimization of the Clear+ mode or only want
it partially, you can adjust it individually in 4 levels
each. A higher value provides more details and
higher sharpness.
At the same time, this increases the image noise.
We therefore recommend the value 2 off and 2 on.
9. Digital zoom
Press the up earrow key for 2 seconds to digitally
zoom the image 2x or 4x. Please note that this is not
an optical zoom and the image section is digitally
enlarged by 2x or 4x. If you want to optimally adjust
the sharpness in 1x magnification, it is recommended
that you focus the device on a high-contrast edge
(house, stone or even a car) in 2x zoom and then
switch back to 1x magnification.
10. Photo and videos
In normal display mode, briefly press the photo key
dto take photos. For 1 second, a photo icon appears
next to the Wifi icon. Press the photo key dfor 2
seconds to capture video. A video icon flashes in the
lower right corner. Press again for 2 seconds to end
video saving.
11. Heat detection
Press the down arrow key
g
for 2 sec. to start the
heat detection function. The hottest point is marked
with a square and moves around depending on the
image situation. To deactivate the function, press the
down arrow key
g
again for 2 seconds.
