Alpine NVE-M300P Technical manual

NVE-M300P Version 2010/03/18
Software Update Guide

Introduction
Requirements
Prepare USB stick - Format USB stick
This Guidebook describes the procedure for updating the NVE-M300P software.
XHigh Speed Internet connection
XUSB stick (minimum 64 MB)
XConnect the USB stick to the PC.
XRight click on “Removable Disc”. The Drive name may vary on your PC and click “Format”.
XDisable “Quick Format” and click “Start”.
XClick “OK” after the formating is completed.
1

2
Prepare USB stick - Prepare update image
XDownload the file “FU_NVE-M300P_xxxxxxxx.zip” to your PC.
XExtract the zip file onto the prepared USB stick.
XThe USB stick must contain the following file and folders structure :
XRemove the USB stick by selecting “Safely Remove Hardware” on your PC.

3
Update the NVE-M300P
XInstall and switch-on the navigation system (Monitor with NVE-M300P).
XConnect the USB stick to the navigation system. Please use the USB cable delivered
with the NVE-M300P.
XThe system will reboot automatically after a few seconds.
XThe update will start after the reboot.
XPlease wait untill the process bar reached 100%.
XDisconnect USB stick
XThe system will reboot after one minute.

4
Verify update process
XTo verfiy the update process please select Main Menu - Settings - About
XCompare version number and release date.
XThe file “Update.log.txt stored on the USB stick during the update process
shows details about the update process (success / failure).
Initialisation of RUE-M300
XConnect the USB IR Receiver RUE-M300 to the NVE-M300P via the USB cable delivered
with NVE-M300P. Standard USB extension cables can be used if length is not sufficient.
XTo activate RUE-M300, press any button at the remote controller except the TMC button.
After this initialisation the RUE-M300 Remote Controller is ready for use.