AlpsAV Soft-Touch Wall Mount Instruction Manual

SOFT-TOUCH WALL MOUNT
INSTALLATION GUIDE & PARTS LIST
Please read all pages prior to installation!

Installation guide
2
PARTS LIST
REF PART NAME QTY REF PART NAME QTY
Wall mount
Interface Arm
VESA 600mm Extension Arms
1 1
2
3
2
2
M6 x 10mm Screw
M6 Washer x 2mm
4 4
5 4
1
3
2
5
4

AlpsAV.com
3
INTERFACE KIT
REF INTERFACE KIT QTY REF INTERFACE KIT QTY
M6 x 16mm Screw
M6 x 25mm Screw
M6 x 40mm Screw
M8 x 16mm Screw
M8 x 25mm Screw
M8 x 40mm Screw
A 4
B 4
C 4
D
E
F
4
4
4
M8 x 5mm Spacer
M8 x 13mm Spacer
M6 washer (for parts A-C)
M8 washer (for parts D-F)
M8 x 25mm Spacer
G 4
H
J
K
4
4
4
I 4
ABC
DEF
GHI
JK

Installation guide
4
INSTALLATION SAFETY INSTRUCTIONS
This mount is intended for use with screens up to 40kg/88lbs. Exceeding this weight can result in
instability causing damage or injury. Always use caution when installing.
Do not attempt to install this product until all instructions and warnings have been read and properly understood.
Please keep these instructions for future reference.
Please check carefully to make sure there are no missing or defective parts. Defective parts must never be used.
AlpsAV, its distributors and dealers are not liable or responsible for damage or injury caused by improper installation,
improper use or failure to observe these safety instructions. In such cases, all guarantees will expire.
General
AlpsAV recommends that a professional AV installer or other suitably qualied persons, install this product. Great care
must always be taken during installation as AV equipment is fragile, possibly heavy and easily damaged.
If you do not fully understand the instructions or are not sure how to install this product safely, then please consult a
professional for advice and/or to install this product for you. Failure to mount this product correctly may cause serious
injury or death both during installation and at any time thereafter.
Do not mount any AV equipment that exceeds the specic weight limit of the product you are installing. This weight
limit will be
clearly stated on each product and its packaging and will vary from product to product.
Product location
Please pay careful attention to where this product is located. Check load capacity of wall prior to installation as some
walls are not suitable for installation. Designed for indoor use, this mount is suitable for public or home installation.
If located in a public area, ensure the product is out of the immediate reach of people. If any AV equipment is to be
suspended over the likely path or location of people, then great care must be used, ensuring all equipment is securely
xed to a wooden stud, concrete block or other permanent structure.
Installing on drywall boards alone will not support the weight of most AV equipment.
When drilling holes in walls it is essential to avoid contact with electrical cables, water or gas pipes, contained within.
Use of a good quality live wire detector and hidden abscess locator is therefore recommended.
Only drill into structures when you are sure it is safe to do so.
Fixing hardware
It is highly recommended that all wall xings be used where supplied and that the purpose of all hardware is fully
understood.
In some cases, more AV equipment xing hardware will be supplied to accommodate different models of equipment
and set up congurations.
The installer must be satised that any supplied xing hardware is suitable for each specic installation. If any xing
screws or included hardware are deemed not sufcient, for a safe installation, then please consult a professional or
your local hardware store.
Hazard limitation
When routing cables take advantage of any built-in cable management features that the product might provide
and ensure that all cables are properly routed and secure. Check to see that any moving aspect of the product
can do so unhindered by any cabling.

AlpsAV.com
5
CONTENTS
Parts list
Installation Safety Notes
Warning
Installation Instructions
Single Screen Installation
Multi-Screen Installation
Product Dimension
AlpsAV contact
Installation tools required
Drill Drill bit LevelPencil
Some products have moving parts and the potential to cause injury through the crushing or trapping of ngers or
other body parts, exercise care and read all warnings.
Pay close attention to all moving parts, especially when assembling, installing and servicing. Immediately after
installation, double check that the work done is safe and secure. Double check all necessary xings are present
and suitably tightened.
It is recommended that periodic inspections (not greater than 6 months apart) of the product and its xing points
are made, to ensure safety is maintained. If in doubt, consult a professional AV installer or other suitably qualied
person.
Periodic Inspection Record:
DATE INSPECTED BY LOCATION SIGNED

Installation guide
6
WARNING
ES
AlpsAV Ltd. recomienda que un instalador de audio y video profesional u otra persona debidamente cualicada instalen este
producto. AlpsAV Ltd, sus distribuidoresy concesionarios no se hacen cargo ni se responsabilizan de ningún daño o lesión
provocados por una instalación inapropiada. Este producto se debe montar en una estructura adecuada y se debe utilizar
soportando solamentre hasta el peso máximo indicado.
FR
AlpsAV Ltd. recommande de coner I’installation de ce produit à un installateur AV professionnel ou à une autre personne dûment
qualiée. AlpsAV Ltd, ses distributeurs et ses revendeurs ne sauraient être tenus resounsables de tout dégât ou de toute blessure
résultant d’ une installation incorrecte. Ce produit doit être monté sur un support approprité et utilisé dans la limite du poids
maximum indiqué.
DE
AlpsAV Ltd. empehlt, dass dieses Produkt durch einen qualizierten AV-Techniker oder eine andere Person mit geeigneter
Qualikation installiert wird. AlpsAV Ltd, ihre Distributoren und Händler können nicht für durch fehlerhafte Montage verursachte
Beschädigung oder Verletzung haftbar bzw. verantwortlich gemacht werden. Dieses Produkt muss auf eine geeignetem Untergrund
montiert werden und darf nur bis zum angegebenen Höchstgewicht verwendet werden
IT
AlpsAV Ltd. consiglia di afdare I’installazione di questo prodotto a un installatore specializzato o ad altra persona adeguatamente
qualicata. AlpsAV Ltd. i suoi distributori e rivenditori non accettano alcuna responsabilità nei riguardi di eventuali danni o infortuni
causati da un’errata installazione. Questo prodotto deve essere ssato a una struttura idonea e utilizzato unicamente sino al peso
massimo indicato.
NL
AlpsAV Ltd. adviseert om dit product te laten installeren door een professionele AV-installateur of andere hiervoor gekwaliceerde
persoon. AlpsAV Ltd. haar distributeurs en dealers zijn niet aansprakelijk of verantwoordelijk voor schade of letsel die is veroorzaakt
door onoordeelkundige installatie. Dit product moet worden gemonteerd aan een geschikte constructie, waarbij het aangegeven
maximum gewicht niet mag worden overschreden.
PT
A AlpsAV Ltd. recomenda que a instalação deste produto seja efectuada por um instalador de AV instalador de AV prossional
ou outra pessoa devidamente habilitada. A AlpsAV Ltd. e os seus distribuidores e concessionários não são responsáveis por
danos ou lesões causados por uma instalação incorrecta. Este produto tem de ser montado numa estrutura adequada e utilizado
somente até ao peso máximo indicado.
PL
Firma AlpsAV Ltd. zaleca, aby ten produkt był instalowany przez profesjonalnych instalatorów AV lub inny odpowiednio przeszkolony
personel. Firma AlpsAV Ltd, jej dystrybutorzy i dealerzy nie ponoszą odpowiedzialności za uszkodzenia lub obrażenia ciała
powstałe w wyniku nieprawidowej instalacji. Niniejszy produkt musi być zamontowany na odpowiedniej powierzchni, a podczas
u żytkowania nie wolno przekraczać podanego maksymalnego obciążenia.
CS
Společnost AlpsAV Ltd. doporučuje provést instalaci tohoto produktu instalátora AV či jinak způsobilé osoby. Společnost AlpsAV
Ltd, její distributoři a prodejci nenesou prostřednictvím odborného odpov ědnost za škody nebo zranění způsobená nevhodnou
instalací. Tento výrobek je nutno umístit do vhodné konstrukce a používat jen po uvedenou maximákní výšku.
RU
AlpsAV
AlpsAV
Warranty period : 2 Years
This AlpsAV product, delivered new, in the original carton to the original consumer purchaser, is warranted by AlpsAV
against manufacturing defects in materials and workmanship for the warranty period above. This warranty begins on the
original date of purchase. To receive warranty service, the purchaser must contact AlpsAV for problem determination and
service procedures. Warranty service can only be performed by a AlpsAV authorized service centre. The original dated bill of
sale must be presented upon request as proof of purchase to AlpsAV authorized service centre.

AlpsAV.com
7
INSTALLATION INSTRUCTIONS
Step 1
Open top and bottom
Handwheels
Interface Arms Extension Arms
Step 2 Attach the interface adaptors to the at screen
The interface arms t from VESA 200 x 100mm through 400 x 400mm.
For 600 x 400mm or 400 x 600mm use supplied extension arms.
For VESA 600x400 LandscapeVESA 400x400
(Shown)
For VESA 400x600 Portrait
TV SCREEN BACK
Unpack and check all parts
Open top and bottom handwheels on Interface Arms (closed for shipment).
Check depth and lateral adjustment knobs are centered in adjustment range.
Center
Center

Installation guide
8
SINGLE SCREEN INSTALLATION
Step 1
Step 2 Tighten all bolts
Step 3 Extend Mount from wall
At slight angle hook arms onto top of frame atten screen onto mount base until it clicks into
position
Measure, mark and drill holes
Use level to check alignment.
Tighten all wall bolts (5 pcs recommened).
Wall xing holes
Level
Use minimum 2 wall bolts (3 recommended) at
Top and 2 wall bolts bottom of mount. Heavier
screen should have 3 bolts including center top
keyhole location.

AlpsAV.com
9
Step 4
Step 5
A : Height adjustment
B: Corner depth adjustment
C: Lateral macro adjust
D: Lateral micro adjustment
E: Screw to secure
Use level to make any needed adjustments to screen
Use locking handwheels (E) to secure screen.
Note: Once secured, locking handwheels must be loosened before any adjustments can be made.,
Height adjustment
Lateral macro
adjust
Lateral micro
adjustment
Tighten to secure
Corner depth
A
C
B
B
E
D
C
Lateral Smart-Lock
1) unlock lateral Smart-Lock,
2) slide screen into position,
3) slide Smart-Lock to interface arm,
4) lock Smart-Lock.
5) After Smart-Lock is in position,
the lateral micro adjustment can be
used.

Installation guide
10
Detail Screen adjustments
A
B
CD
Height Adjustment
Corner depth adjustment
Lateral macro adjustment Lateral micro adjustment

AlpsAV.com
11
MULTI- SCREEN INSTALLATION
IV
II
General recommendations
Check the wall structure being mounted to. Use a level to ensure the wall is at and note areas of
concern. Use washers, shims or spacers between the wall and the mount to create a at surface
for mounting. A at mount will make adjustments much easier and faster when aligning screens.
Note: The AlpsAV Soft-Touch Mount is ONLY suitable for installation perpendicular or slightly
angeled to the oor in portrait or landscape orientation. It is NOT suitable for overhead
mounting.
We recommend video walls start in a corner, we show starting at the bottom left then add the
screens row by row, aligning the screens as you build. Also, make sure depth and lateral micro
adjustments are centered before installation, making alignment quicker and easier.
Note: Walls are built from different materials and require different wall bolts for best performance
and safety. Please select suitable fixings or consult an expert for guidance.
Start from the bottom corner of the video wall
conguration.
Height of screen determines center to center distance
for next vertical mount location.
Width of screen determines center to center distance
for next horizontal mount location.
Build Horizontallly rst then add rows until all rows are
completed.
3 3 4
11
1
22
21
Align the one common border
before mounting the next screen
Align the two common borders
before mounting the next screen
I
III

PRODUCT DIMENSIONS AV02
Alps AV
Austria | Netherlands | USA: Nevada & New York | Hong Kong | Vietnam
www.AlpsAV.com EU USA [phone]
[phone]
[e-mail]
FRONT VIEW LANDSCAPE ADAPTOR
VESA 600mm X 400mm
FRONT VIEW PORTRAIT ADAPTOR
VESA 400mm X 600mm
18.4’’
468mm
FRONT SIDE VIEW OPEN SIDE VIEW CLOSED
15.75’’
400mm
23.6’’
600mm
15.75’’
400mm
23.6’’
600mm
20.9’’
531mm
22.6”
574.5mm
9.8’’ (+/-0.3)
295mm (+/-10mm)
3.9’’ (+/-0.3)
100 mm (+/-10mm)