Alvin PMT100D User manual

Tube Center Display PMT100D – PMT200D
Tools required: Phillips screwdriver, pliers or wrench, and double-sided tape.
Assembly Instructions
Parts included:
Unpack and inspect contents to confirm you
have all parts listed above.
Connect back cross brace to right side frame
using two screws and two wing nuts, as
shown in Figure 1. Wing nuts should be on
the inside of the frame.
Set assembly down with cross brace on floor.
Connect top, middle, and bottom grid panels
to right side frame using six capped nuts.
Connect left side frame to grid panels using
six capped nuts.
Screw four casters into bottom tubes of side
frames. Turn assembly upright.
Connect back crossbar to left side frame
using two screws and two wing nuts.
Attach display sign to front of assembly using
four snap buttons. You may choose to utilize
double-side tape to help secure the display
sign in position.
2 pcs
Side frame
1 pc
Bottom grid
panel
2 pcs
Middle and
top grid panel
(PMT200D)
1 pc
Front display sign
4 pcs
Screws for
cross brace
4 pcs
Wing nut
12 pcs
Capped nut 4 pcs
Push buttons for sign
2 pcs
Middle and
top grid panel
(PMT100D)
4 pcs
Caster
1
1 pc
Back cross brace
To assemble:Unpack and inspect contents to confirm you have all parts listed above.
Figure 1
2
3
Figure 2
4
5
6
7
or
8

©2008 ALVIN & COMPANY, INC. • P.O. Box 188, Windsor, CT 06095-0722
Phone: [phone] • Toll-Free: 800-444-2584 • Fax: [phone] • Toll-Free Fax: [phone] www.alvinco.com
LIT-A7157 4/08
PMT100D PMT200D