OPERATION:
1.
Connect the signal cable from your monitor to the TTL
l/P
(9
PIN
"D"
TYPE) connector
in
the back
of
the personal computer. (Refer to
l/P
connector layout)
2.
Connect the power cord with specified outlet,
and
pull the
PULL
ON
switch
to
set the unit
on.
It
will
be
a few seconds before the picture comes
on
to the screen.
3 Adjust the CONTRAST
and
BRIGHTNESS controls to make the picture
at
the level
most
pleasing to your eyes.
4.
To
adjust the picture to the center
of
the screen, use
H-CENTER
for
horizontal adjustment,
and
V-HOLD
for
vertical adjustment.
CAUTIONS:
1.
Do
not use or store this monitor
in
a place with much moisture or dust,
or high ten:iperature such
as
kitchen appliances,
direct
sunshine, etc.
2.
Do
not cover the ventilation
slits
while
in
operation. This will prevent the
necessary ventilation.
3.
When
the screen surface
filter
develops dusts, clean with
soft
cloth
moistened with water. Special cleaning cloth is also available from your
local dealer.
4.
When
the monitor is not
in
use for a long time,
be
sure to pull the power
plug out
of
the outlet.
