Amer Mounts HYDRA1A User manual

COUNTERBALANCE
MONITOR ARM
Instruction Manual
5
HYDRA1A 2~9kg
4.4~19.8lbs
RATED
VESA Compatible
75x75 100x100
First, position and firmly hold the arm horizontally
as shown. Ask for assistance should you require it.
To properly balance the arm with monitors mounted, adjust the spring tension using the supplied
Allen Key as follows:
CAUTION:To avoid damage to monitors or
mount, always keep the arm in a horizontal
position while making adjustments.
Again, ask for assistance if required.
6
Arm can rotate without stopping.
±180°±180°±180°
Arm can rotate 180°.
Remove or loosen the limiting screw.
Tighten the limiting screw
(do not over tighten).
7±90°±90°±90°
Note:Ifthedisplaydoes
notstopatyourdesired
position,tightenthe
screwsasshown.
8
Note:Ifthedisplay
doesnotstopatyour
desiredposition,
tightenthescrewas
shown.
If the arm drops, turn the adjustment
screw clockwise until it stays
in a horizontal position.
If the arm rises, turn the adjustment
screw counter-clockwise until it stays in a
horizontal position.
O
N
N
O
N
FLAT/CURVED
32"
MAX
CAUTION:
·Do not over tighten the screws.
·To prevent damage to the Tension
Indicator, never allow the Red Indicator
Line move beyond the “ ” and “ ”
found on the Left and Right Side of the
tension indicator.
N

C
M-C (x4)
D5
M-B (x4)
M5x12
M-A (x4)
M4x12
12
3
Too long Too Short
10-55mm10-55mm10-55mm
OR
50-85mm50-85mm50-85mm
4
Unlock
Lock
10-80mm
ø 10mm
(ø 3/8")
OR
K
L
H
I
1
2
D
D
M
10-80mm
ø10-60mm
Desktop with Existing Through-Hole.
N
A
B
N
J
G
F
N
J
E
F
N
M
2
N
3
N
A (x1) B (x1) G (x1)F (x1)E (x1)D (x1)C (x1) H (x1)
P (x1)
10-13mm
K (x1) L (x1) M (x2)J (x3)
M6x12
I (x1) N (x1)
4mm
O (x1)
5mm
1
EN
6mm
M-A
M-B
M-C
P