American DJ LTS-6 User manual

LTS-6™ Portable Trussing System
LTS-6 Parts List:
• 1 x Tripod stand
• 1 x T-bar
• 2 x collars
• 2 x telescoping posts
• 4 x adjustment knobs
• 4 x bolts and wing nuts
Instructions for using your LTS-6™:
1. Set up the Tripod stand by adjusting the width of its legs. When the desired width has been selected, tighten
the knob on the base of the Tripod.
2. Adjust the telescopic center posts by loosening the knobs on the collars to the preferred height. The posts will
slide into one another going from the largest at the bottom to the smallest at the top. Tighten the knobs in the
collars.
3. Fasten the four bolts and four wing nuts into the T-bar. Finish by placing the T-bar connection into the top-
most center post. It will only fit in the smallest post. Tighten the knob on the collar.
4. Reposition if needed, recheck all knobs, and tighten all fastners before mounting any fixtures to your com-
pleted LTS-6 trussing system.
©American DJ ® Los Angeles, CA 90058 USA