AMERICAN IMAGE DISPLAYS EDGE Eurofit Curve User manual

Instructions Continued On Back Side
EDGE Eurofit Curve iPad Stand Instructions
Hardware Assembly
Step 1
Open all parts to the hardware and
assemble the parts using the diagram
illustrated to the right.
Product Parts
1 - Hardware
a - Top Curved Pole
b - Bottom Curved Pole
c - Angled Side Poles (x2)
d - Curved Side Poles (x2)
e - Bottom angle poles (x2)
f - Top Horizontal Pole
g - Bottom Horizontal Pole
h - Tablet Bracket
i - Tablet Knobs (x2)
2 - Graphic
a
a
c
cc
e
f
i
f
b
b
e e
g
g
d
d d
2
h
Warranty Information: All products are designed to provide the user with a cost-effective and durable product. Standard warranty is a ‘one year parts and labor’ warranty which
warrants product against defects in material and workmanship. It does not cover damage due to accidents, abuse, or normal wear and tear. Products found to be defective will
be replaced or repaired at factory’s discretion.

Warranty Information: All products are designed to provide the user with a cost-effective and durable product. Standard warranty is a ‘one year parts and labor’ warranty which
warrants product against defects in material and workmanship. It does not cover damage due to accidents, abuse, or normal wear and tear. Products found to be defective will
be replaced or repaired at factory’s discretion.
Storage
Store in a cool dry location.
Care
Graphic Setup
Step 1
Set the assembled hardware on a clean surface. Locate
the bottom of the graphic (zippered end) and slide it over
the top of the hardware and continue to slide down the
over hardware.
Step 2
Zip the Graphic Closed along the side and around the
bottom.
Step 3
Attatch the Tablet
Bracket (h) as shown
using the Screws (i)
provided.
NOTE:
The graphic is designed to fit the hardware
precicely, as a result the graphic may appear
to be too tight during the installation process
(this is normal).
Machine wash cold, gentle cycle. Air Dry Only
h
e
i