Amica AMM20BI User manual

Microwave Oven
Before using the microwave, please carefully read this manual.
Installation Manual
AMM 20 BI
IO 00505

3
DEAR CUSTOMER,
Please read this manual carefully before you start to use this microwave. This way,
you can ensure its proper and correct operation.
Please preserve this manual and store it near the appliance, so that it is available
at all times for reference.
Observe the instructions contained herein to prevent accidents.
Important!
The appliance is designed for household use only.
The manufacturer reserves the right to introduce changes which do not affect the
operation of the appliance.
Before using the microwave, please careful-
ly read this manual. Store it in such a place,
so that it may be used in future. Please
follow the instructions to ensure many years
of reliable operation of your oven.

4
EQUIPMENT
ADJUST SCREW A
SCREW B
TRIM-KIT PLASTIC
COVER
Frame
BUILT-IN FURNITURE
The built-in cabinet shall not have a rear wall behind the appliance.
Minimum installation height is 85cm.
Do not cover ventilation slots and air intake points.
Electrical connection
The oven is tted with a plug and must be only connected to a properly installed ear-
thed socket. In accordance with the appropriate regulations, the socket must only be
installed and the connecting cable must only be replaced by a qualied electrician. If
the plug is no longer accessible following installation and all-pole isolating switch must
be present on the installation side with a contact gap of at least 3mm.
SCREW C

5
BUILT-IN FURNITURE
3. INSTALL THE OVEN
LONG FEET
a) Turn over the oven and install LONG
FEET provided in the accessory pac-
kage.

6
INSTALL THE OVEN
SCREW B
b) Fix ADJSUT SCREW A on the UPPER AIR TUNNEL of the oven, and x
the TRIM KIT with SCREW B. Then install the oven into the cabinet.
Make sure that the upper side gap between the TRIM KIT and the oven is
the same as the bottom side.
Make sure that the minimum left side gap between the TRIM KIT and the
oven is at least 9 mm.
Adjust the height of ADJUST SCREW A to keep 1 mm gap between the
ADJUST SCREW A and the top plane of cabinet. Do not trap or kink the
power cord.
ADJUST SCREW A UPPER AIR TUNNEL
TRIM-KIT
ADJUST HEIGHT
ADJUST SCREW A
TRIM KIT
SCREW B
SCREW B SCREW B
c) Open the door; x the oven in the cabinet with SCREW C at the
INSTALLATION HOLE of TRIM KIT. Then x the TRIM-KIT PLASTIC
COVER to the INSTALLATION HOLE.
INSTALLATION
HOLE
INSTALLATION
HOLE
SCREW C TRIM-KIT PLASTIC
COVER

7

IO 00505