Anchor TM45 User manual

FE
G1
G3
x3
wood stud
E
G1
G3
x3
Recommended Tools
• Power drill
• 5/32” drill bit for drywall
• 3/8” or 10mm drill bit for concrete
• Stud nder
• Phillips screwdriver
Included Parts
x4
B1
M5x12mm
M5x20mm x4
B2
A1 x4
M4x12mm
A2
x4
M4x20mm
x4C2 M6x20mm
x11G1 ø6
G2 x4
ø8
H1 x4
ø8x5
Ix4
Jx4
Allen Wrench
5x5
Kx1
H2 x4
ø8x10
H3 x4
ø8x20
M6x12mm x4C1
x4
D2
M8x20mm
x4
D3
M8x50mm
ø10x50 x3F
x3E M6x50mm
M8x15mm x4
D1
G3 x1
Bubble
Level
x4B1 M5x12mm
M5x20mm x4B2
A1 x4
M4x12mm
A2 x4
M4x20mm
x4C2 M6x20mm
x11G1
ø6
G2
x4
ø8
H1
x4
ø8x5
Ix
4
Jx
4
Allen Wrench
5x5
Kx
1
H2
x4
ø8x10
H3
x4
ø8x20
M6x12mm x4C1
x4D2 M8x20mm
x4D3 M8x50mm
ø10x50 x3F
x3E M6x50mm
M8x15mm x4D1
G3
x1
Bubble
Level
Full Motion Flat Panel TV Mount for 13-65”Televisions
User’s Guide for Model TM45 v1949-03
Step 1A: Mounting to Drywall
• DO NOT DRILL AND HANG THE MOUNT DIRECTLY TO DRYWALL OR
SHEETROCK. They are not strong enough to support a TV and will cause damage
if used this way.
• Use a stud nder to locate studs behind drywall.
• Pre-drill 3 holes into the stud using a 5/32”
drill bit. Note the 3 screw hole locations for
attaching to a stud dier from those used for a
concrete wall.
• Attach the Swing Arm rmly to the wall using
the supplied washers and screws.
Step 1B: Mounting to Concrete Wall
• Pre-drill 3 holes into the wall using a 3/8” or 10mm drill
bit. Note the 3 screw hole locations for attaching to a
concrete wall dier from those used for a stud.
• Insert the 3 wall anchors into the holes and attach the
Swing Arm rmly to the wall with the supplied washers
and screws.
Warnings
• The wall mounted parts of the TV mount must be rmly attached to a concrete/
brick/solid wood wall, or wall studs behind drywall.
• Tighten screws so that the wall plate is rmly attached, but do not overtighten.
Overtightening can damage the screws and increase the chances of failure.
• Do not remove or loosen any screws until they are no longer engaged with the
mount. Doing so may cause the screen to fall.
• It is highly recommended to have this mount professionally installed.
• Supports VESA mounts up to 400 x 400mm (100 x 100mm for 13”TVs).
• This mount is designed to hold a maximum of 60 lbs (27 kg).
WARNING: This product can expose you to chemicals including lead,
which is known to the State of California to cause cancer and birth
defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov. This product meets and complies with
all Federal regulations.

Step 2: Attach Mounting Plate to Television
For TVs with 100mm VESA mount
• The extension arms are not needed. Align the holes on the Mounting Plate with those on the TV and use the included hardware to
secure the Mounting Plate to the TV.
• Not all of the included screws and washers will be needed, nd the set that best ts your TV and discard the rest. The rubber
washers (H1/H2) can be used as a spacer between the TV and the Mounting Plate.
G1
A1/B1/C1
D1
G2
K
J
G1
I
G1
A2/B2/C2
H1/H2
D2
H1/H2
G2
D3
H1/H2/H3
G2
cable tie
-1°/+15°
Step 3: Hang Television on the Swing Arm
• For larger TVs, It is highly recommended to use at least two people to hang
the TV.
• Attach the TV and Mounting Plate to the Swing Arm and use the included Allen
Wrench (K) to secure the Mounting Plate to the Swing Arm.
For TVs with 400mm VESA mount
• Attach the extension arms to the Mounting Plate, making sure the arms are in a position that will t your TV.
• Use the included hardware to secure the Mounting Plate/Arms to the TV.
• Not all of the included screws and washers will be needed, nd the set that best ts your TV and discard the rest. The rubber
washers (H1/H2) can be used as a spacer between the TV and the Mounting Plate Arms.
Adjust Tilt Angle
As the mount is used, It may be necessary to ne-tune and readjust the TV to a level
viewing position.
• Use the included Allen Wrench (K) to slightly loosen the screws holding the
Mounting Plate to the Swing Arm.
• Set your desired tilt angle and tighten the screws.
This TV mount will accommodate TVs up to 65”with a maximum weight limit of 60 lbs. Please check your TV’s
owners manual before installing. Do NOT overload with too much weight for risk of injury or damage that
may occur.