Apeks LUNA-X User manual

All controls for the LUNA-X are found on the light head unit.
There are 2 function buttons which operate the mode and output level.
There are 3 modes – Spot, Wide and Full.
Each mode has 3 power levels – High, Medium, and Low.
·Before rst use connect the LUNA-X battery to the charger and charge
until the LED on the charger goes from Red to Green. This indicates it is
fully charged.
·Connect the battery to the lights head.
·The battery charge percentage will be displayed for 5 seconds.
The bi-colour LED and the OLED screen informs you of the output level on the
left, the remaining runtime in the centre and the mode on the right.
QUICKSTART GUIDE
APEKS LUNA-X
OLED Screen
Mode
Function Button
Output
Function Button
APEKS DISCLAIMS AND EXCLUDES ANY LIABILITY FOR INCIDENTAL OR
CONSEQUENTIAL DAMAGES. SOME STATES IN THE U.S. AND CERTAIN
OTHER COUNTRIES DO NOT ALLOW EXCLUSIONS OR LIMITATIONS OF
LIABILITY FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES, SO THIS
MAY NOT APPLY TO YOU.
Restrictions
The following restrictions apply to this warranty:
1. This warranty does not cover normal wear.
2. This warranty does not extend to damages caused by improper use,
improper maintenance, neglect, unauthorised repairs, modications,
accidents, re, or casualty.
3. Cosmetic damage, such as scratches, dents and nicks are not covered
by this warranty.
4. This warranty does not extend to equipment used for rental,
commercial or military purposes.
In the unlikely event that you experience a problems with your Apeks light
please contact your local Apeks dealer.
A dealer locator is available on our website: apeksdiving.com
For more information please visit:
apeksdiving.com
EXPUG28
Apeks Lights are very powerful lighting systems. Always take care when
operating. Do not look directly into the light. This may cause serious injury. Do
not shine directly at others.
Warranty Information
All warranty transactions must be accompanied by proof of original purchase
from an authorised dealer. Be sure to save your sales receipt, and present it
whenever returning your torch for warranty service.
Limited 2 year Warranty
Apeks warrants to the original purchaser that the product will remain free
from defects in material and workmanship for 2 years provided that it receives
normal use, proper care and maintenance. This warranty does not apply
to units subjected to misuse, abuse, neglect, modication, or unauthorised
service. This limited warranty is extended only to the original purchaser
for products purchased directly from an authorised dealer, and is not
transferable.
This warranty is limited to repair or replacement only at the discretion of
Apeks.
WARNING
MODE SELECTOR
MODE (Hours / Lumens)
BEAM H M L
Full 3 / 3300 6 / 1800 14 / 850
Wide 5 / 2000 8 / 1350 12 / 1000
Spot 6.5 / 1350 10 / 1000 14 / 750
LIGHT OPERATION
SETTING UP
EXPUG28.1.indd 1,3EXPUG28.1.indd 1,3 13/03/2023 15:5113/03/2023 15:51

·To turn the LUNA-X ON double click either button. The light will illuminate
in the mode and output it was last operated in.
·To change the output power click the left hand button.
·To change the mode click the right hand button.
·To switch the LUNA-X OFF, press and hold either button for 1 second.
·To enter Strobe mode, from OFF, press and hold either button for 3
seconds.
To enable Travel Lock, from OFF, press and hold both buttons for 1 second.
The buttons will now be disabled.
To disable Travel Lock, press and hold both buttons for 1 second. The buttons
will be re-enabled.
Travel Lock is automatically disabled if the battery is disconnected and then
reconnected.
From OFF, press either button once to display
the battery percentage.
When the LUNA-X is switched ON or after the
mode or output is changed the OLED display
indicates the remaining runtime in hours and
minutes for 10 seconds.
For quick indication the bi-colour LED reects the
percentage of battery remaining.
Patented technology combats loss in efciency of LEDs at elevated
temperatures. The technology maintains optimum output for maximum
efciency.
There is an optimum temperature where the balance between light output and
battery burn time peaks, beyond this LEDs become inefcient.
The intelligent circuitry of ITM monitors the temperature of the LEDs and
adjusts power accordingly to ensure the LEDs remain at there optimum
efciency. The adjustment of the power doesn’t noticeably drop the light
output, it only maximises burn time. The combination of ITM and our advanced
body design increases heat dissipation to ensure that no power is wasted,
maximising burn time.
FUEL GAUGE FUNCTION
ITM (INTELLIGENT THERMAL MANAGEMENT)
LED BATTERY %
GREEN 100 – 85%
GREEN PULSE 85 – 70%
AMBER 70 – 55%
AMBER PULSE 55 – 40%
RED 40 – 25%
RED PULSE 25 – 10%
RED FLASH 10% – Empty
WARNING: Only use the supplied or recommended charger when re-charging
your LUNA-X.
WARNING: Don’t allow any water into the charge port or connector cable. If
water does enter the charge port or connector cable ensure it is completely
clean and dry before reconnecting the battery to the light.
• Whilst charging the LED on the plug will illuminate RED.
• Once the Battery pack is fully charged the LED on the plug will
illuminate Green.
• The battery will take up to 9 hours for a full charge.
RE-CHARGING INSTRUCTIONS
SPECIFICATIONS
Inspect and test your Apeks light before every dive.
Keep your light clean, and the lens free of dirt and salt. The lens is made of
tempered glass but can be scratched. Be careful when cleaning your light.
Never use a high pressure hose. Do not use harsh abrasive or corrosive
materials to clean your Apeks Light. Soak and rinse in fresh water after each
dive.
MAINTENANCE
Overall weight (w/o handle) 875g
Head and cable weight 341g
Dimensions head 62mm diameter, 46mm length
Dimensions battery 53.5mm diameter
Total battery length 165mm
Cable length 1180mm
Battery type Lithium-Ion
Battery weight 535g
Battery capacity 27.2Ah
Charge time 9 hours
Minimum runtime 3 hours
Maximum runtime 14 hours
Minimum output 750 lumens
Maximum output 3300 lumens
Beam angle Wide 80 degrees
Beam angle Spot 8 degrees
Certications CE, ROHS
SETTING UP (Continued)
EXPUG28.1.indd 4-6EXPUG28.1.indd 4-6 13/03/2023 15:5113/03/2023 15:51